Advance acoustic SC6000 Installation instructions

9435 Winnetka Avenue North
Brooklyn Park, MN 55445
www.advance-us.com
Phone [phone]
Fax [phone]
240 Superior Boulevard
Mississauga, Ontario, Canada L5T 2L2
www.nilfisk-advance.ca
Phone [phone]
Fax [phone]
ATTENTION! Do not use the machine before you read and understand the Instructions for Use Manual.
18. Press “i” scroll down to faults and
press “>” button to view faults.
16. Adjust water flow. 17. Adjust detergent concentration.
2. E-stop icon appears on display
when E-stop switch is engaged.
Twist E-stop switch to enable
machine function.
1. Check the battery charge gauge
(and if necessary re-charge).
3. Check that battery cables are
connected.
4. Recovery tank seal cover must be
correctly installed and in good
condition. Clean and empty
debris tray.
5. Inspect the squeegee blades/skirts
for damage.
7. As necessary adjust the tilt angle of squeegee so blade has uniform contact
tip to tip. Verify squeegee casters rotate and pivot freely and are in contact
with the floor when squeegee is in the down position.
6. Install squeegee. 8. Open brush door compartment and check brushes for debris.
15. Ensure that the deck and squeegee
are moving down when pressing
the button.
13. Adjust side skirt heights and inspect
blades for wear or damage.
14. Lift side skirts when double
scrubbing is needed.
10. Remove and periodically clean
solution filter screen.
11. Verify vacuum filter and screen
are clean.
9. Verify water is in the solution tank. 12. Install brushes by positioning
against guides. Press brush install
button.
USE AND CARE
SC6000™

9435 Winnetka Avenue North
Brooklyn Park, MN 55445
www.advance-us.com
Phone [phone]
Fax [phone]
240 Superior Boulevard
Mississauga, Ontario, Canada L5T 2L2
www.nilfisk-advance.ca
Phone [phone]
Fax [phone]
ATTENTION! Do not use the machine before you read and understand the Instructions for Use Manual.
The machine
doesn’t work
as it should?
The suction
doesn’t work
as it should?
The machine
doesn’t clean
as it should?
The brushes don’t
work as they
should?
TROUBLESHOOTING
SC6000™
1. Remove side skirt assembly and
verify brush installation and
condition.
2. Press “i” scroll down to faults and
press “>” button to view faults.
3. Check if there are external materials preventing the brush from rotating.
1. Check if the suction hose is
properly installed, not plugged,
or cracked/torn.
2. Inspect recovery tank float switch
operation.
3. Check if squeegee blades are
damaged or dirty.
4. Empty debris basket. Recovery tank
seal cover must be correctly installed,
clean and in good condition. Check
for gasket wear.
1. Verify proper solution settings for
soil level.
2. Verify the solution valve is open
and aligned with inlet and outlet
ports of valve.
3. Verify vacuum filter and screen
are clean.
1. Check battery charge gauge. 2. . E-stop icon appears on display
when E-stop switch is engaged.
Twist E-stop switch to enable
machine function.
3. Check battery cables are
connected.
4. Recovery tank seal cover must be
correctly installed, clean and in
good condition.