Advance acoustic SC250 User guide

9435 Winnetka Avenue North
Brooklyn Park, MN 55445
www.advance-us.com
Phone [phone]
Fax [phone]
240 Superior Boulevard
Mississauga, Ontario, Canada L5T 2L2
www.nilfisk-advance.ca
Phone [phone]
Fax [phone]
ATTENTION! Do not use the machine before you have read and understood the Instructions for Use Manual.
2. Fill the solution tank with water.
The water temperature must not
exceed 105° F (40° C).
3. The tank cap can be used for dosing
the detergent. One full cap is 30 ml
giving 0.5% detergent of the 1.6 gal
(6 L) tank capacity. (*)
4. Adjust the handle to the desired
height. Turn the machine on with
the power button.
1. Disconnect the battery charger cord
from the machine and electrical
outlet.
17. Clean the debris collection tray.16. Clean the squeegee bars and
the cylindrical brush with water.
Check for wear and replace
when necessary.
15. Remove the squeegee bars.
Remove the cylindrical brush by
turning the side knob clockwise.
13. Remove the cover and clean it with
hot water. Remove the ball float
cage along with the float and
clean them thoroughly.
12. Empty the recovery and solution
tanks. Clean them out with water.
11. For transporting and parking the
machine, push the pedal down
(slightly lift the front of the machine
by tilting the handlebar).
9. For double scrubbing, press the
vacuum suction button to switch the
vacuum off.
10. Turn the machine off with the
power button.
5. Lift the pedal to lower the machine
and start working.
6. Grab the handles to activate the
brush and solution flow, then start
cleaning the floor.
7. Press the solution button to select
the type of cleaning required.
8. For sweeping functions, lift/lock the
right lever to lift the front squeegees
in order to collect light debris.
When finished using
14. Check and clean the solution and
vacuum filters regularly.
19. Charge the batteries: Connect
the battery charger cord from the
machine to an electical outlet.
18. Clean the machine using a damp
cloth and where needed use a
neutral cleaning product.
20. Store the machine in a clean and
dry place.
(*) ALWAYS FOLLOW THE DETERGENT DOSING RECOMMENDATION ON THE LABEL OF THE CHEMICAL PRODUCT USED.
USE AND MAINTENANCE
SC250™

9435 Winnetka Avenue North
Brooklyn Park, MN 55445
www.advance-us.com
Phone [phone]
Fax [phone]
240 Superior Boulevard
Mississauga, Ontario, Canada L5T 2L2
www.nilfisk-advance.ca
Phone [phone]
Fax [phone]
ATTENTION! Do not use the machine before you have read and understood the Instructions for Use Manual.
The machine
doesn’t work
as it should?
The suction
doesn’t work
as it should?
The machine
doesn’t clean
as it should?
The brush
doesn’t work
as it should?
TROUBLESHOOTING
SC250™
1. Adjust the brush pressure by turning
the regulation knob.
2. Check for brush wear, and make
sure that it is installed correctly.
3. Check to see if there is debris that is
preventing the brush from rotating.
1. Check if the battery is charged. 2. Check if the battery is correctly
fitting in the machine. (*)
3. Machine fault indicated by LED’s
blinking. (*)
(*) For these causes the maintenance
procedure must be performed by an
authorized Advance Service Center.
For further information refer to the
Service Manual, available at any
Advance Service Center.
1. Check if the recovery tank is full. 2. Check if dirt and debris are clogging
the squeegee inlet and if the blades
are worn or damaged.
3. Rinse the inside of the duct recovery
hose with water.
4. Check if the float cage is clean.
1. Check to see if the solution filter is
dirty. Clean it if necessary.
2. Check if the holes in solution
dispensers are clogged. Remove
them and clean if needed.
3. Check to make sure the quick
connect valve is not leaking.