
SNMP-1000-B1 User’s Manual viii
Chapter 3 Getting Started ...............................................18
3.1 Configuring the SNMP-1000-B1 .................................... 18
3.2 Configuration through the Serial Port ............................. 19
3.2.1 Agent Configuration ..................................................... 20
3.3 Communication through Ethernet ................................... 25
3.3.1 Configuration using Telnet ........................................... 26
3.3.2 Configuration using a Web Browser ............................ 26
3.3.3 Remote access through a phone line............................. 26
3.3.4 Setup using the LCD message display module............. 26
Table 3.1:Function Keys of LCD Display Module....... 27
3.3.5 Main Menu.................................................................... 28
3.3.6 Agent configuration ...................................................... 29
3.3.7 Setting the IP address.................................................... 30
3.3.8 Enable/Disable BOOTP/HDCP function...................... 30
3.3.9 Agent Information......................................................... 31
3.3.10 Set System Date ............................................................ 31
3.3.11 Set System Time ........................................................... 32
3.3.12 View Active Alarms ..................................................... 32
3.3.13 View System Status ...................................................... 33
3.3.14 View Fan Speed ............................................................ 34
3.3.15 View Temperature Status ............................................. 34
3.3.16 View Voltage Status ..................................................... 35
3.3.17 View Power Supply Status ........................................... 36
3.3.18 View Digital Input Status ............................................. 36
3.3.19 View CPU Card/ Mother Board Healthy Status ........... 37
3.3.20 View Watchdog Timer Status....................................... 37
Chapter 4 Programming the SNMP-1000-B1................40
4.1 Introduction ..................................................................... 40
4.2 Entering the Pass Through Command Mode .................. 40
4.3 Syntax of Command and Response................................. 42
4.4 List of Device Codes and Device Sub-Codes ................. 43
4.5 Summary of Command Set ............................................. 45
4.5.1 Fan Read ...................................................................... 45
4.5.2 Temperature .................................................................. 47
4.5.3 Voltage.......................................................................... 49
4.5.4 CPU Card...................................................................... 52
4.5.5 Digital Input.................................................................. 60
4.5.6 WDT ............................................................................. 61
Appendix A Connector Pin Assignments ..........................64
A.1 External Buzzer Connector (J1) ...................................... 64
A.2 Bypass Password Protection (MJ1)................................. 64
A.3 External Power Connector (CN1) ................................... 64
A.4 10/100Base-T LAN Connector (CN2) ............................ 65