8
NRL 0280-0750 60Hz
EN
The Units sent from the factory already inspected and
only requires electric and hydraulic connections in the
place of installation.
the customer where the unit is to be installed, whilst
paying attention to the following:
The support surface must be capable of suppor-
other appliances or structures must be scrupu-
lously respected so that the inlet and outlet air
from the fans is free to circulate.
The unit must be installed by an enabled techni-
the minimum technical spaces in order to allow
maintenance.
The machine is delivered from the factory wrapped
in estincoil. Before handling the unit, verify the
lifting capacity of the machines used. After removal
of packaging, movement of apparatus must be
carried out by qualified and adequately equipped
personnel.
The unit must be installed by a quali-
fied and suitably trained technician,
in compliance with the national
legislation in force in the country
of destination (Ministerial Decree
329/2004).
AERMEC will not assume any respon-
sibility for damage due to failure to
follow these instructions.
Before beginning any operation,
READ THESE INSTRUCTIONS CARE-
DANGER TO A MINIMUM. All the
staff involved must have thorough
knowledge of the operations and
any dangers that may arise at the
moment in which the installation
operations are carried out.
4. SELECTION AND PLACE OF
INSTALLATION
1100 mm
43 in
800 mm
31 in
800 mm
31 in
800 mm
31 in
3000 mm
118 in
ATTENTION:
The drawings are only examples.
EXAMPLE
2
"OF THE LIFTING"
NRL 0750 (always use all the provided eyebolts)
Before moving the unit, check the lifting
capacity of the machines used.
Once the packaging has been
removed, the unit must
be handled by qualified per-
sonnel, using the appropriate
equipment.
To handle the machine:
hook the lifting cables to the
special eyebolts In order to
avoid damaging the unit with
the cables, insert protection
elements between them and
the machine. Is it absolutely
forbidden to stand beneath
the unit.
ATTENTION
Always use all the provided eyebolts.
ATTENTION
The unit comes mounted on a pal-
let for handling carts with trucks
and straps predict the poles (NOT
SUPPLIED).
EXAMPLE 1
"OF THE LIFTING"
Size 0280-0700.
Insert pipes (NOT SUPPLIED) in
holes on the base with length
such to allow positioning of the
belts used for lifting.
To prevent the unit structure
being damaged by the belts place
protections between the latter
and the machine.
It is prohibited to stop under
the unit.
NOTE:
The appliance warranty does not cover the costs for lad-
ders, scaffolding, or other elevation systems that may
become necessary for carrying out servicing under
warranty.
4.1. MINIMUM TECHNICAL
5. POSITIONING
