AGF COLLECTanDRAIN 5680A User manual

Inspection:
Unpack the Model 5680A Outdoor Cover
Assembly and carefully inspect it for any
damage caused during shipping.
Verify box contents, each M5680A includes:
• 5680: Outdoor Cover
• 5669: Tie Down
• 5582: Four (4) Stainless Steel Sheet
Metal Screws
• 5583: 45˚ Elbow
Model 5680A
Installation Instructions
AGF Manufacturing Inc.
AGF Manufacturing Inc. • Phone: [phone] • Fax: [phone] • www.agfmfg.com
5680
Outdoor
Cover
M5680A
Mounting
Flange
5669
Tie Down
5582 Sheet
Metal Screws
Installation:
The COLLECTanDRAIN™ M5680A Outdoor Cover Assembly will be installed directly
over the M5450/M5500 Outdoor Model. It attaches to the wall or other secure
structure using the Mounting Flange holes provided (3/8”). AGF recommends
using mounting fasteners (not provided) suitable for the surface to which it is
being mounted.
1. Install the COLLECTanDRAIN™ M5450/M5500 in the
desired location according to the Owner’s Manual
instructions. Make sure all plumbing and electrical
work has been completed within the available space
shown in the diagram. To ease plumbing, the M5680A
Outdoor Cover Assembly includes a 45º inlet elbow.
2. Slide the COLLECTanDRAIN™ M5680A Outdoor Cover
down over the M5450/M5500. The internal tabs of the M5680A should rest
on top of the M5450/M5400 and both sides of the M5680A should be slightly
below the bottom of the M5450/M5500. If not, investigate why and correct the
issue before proceeding to the next step.










3/80%,1*
6$)(=21(

AGF Manufacturing Inc.
100 Quaker Lane • Malvern, PA 19355
Phone: [phone]
Fax: [phone]
www.agfmfg.com
INST-5680A · 12/20
3. Push the COLLECTanDRAIN™ M5680A Outdoor Cover
ush against the mounting surface and, using a clamp
or helper, squeeze the bottom sides of the M5680A so
they are tight against the M5450/M5500. Then, mark
all six (6) hole locations in the Mounting Flange on the
mounting surface.
4. Remove the clamp (if used). Then, lift the M5680A
Outdoor Cover off of the M5450/M5500 and drill all six
(6) hole locations into the mounting surface according
to the fastener’s requirements.
5. Run a bead of caulk or sealant around the back side
of the Mounting Flange; this will prevent rain and snow
from getting behind the unit. Then, carefully slide the
M5680A Outdoor Cover down over the M5450/M5500.
Make sure there is a gap between the Mounting Flange
and the wall to ensure the caulk or sealant does not
smear down the wall.
6. When the M5680A Outdoor Cover comes to rest on
top of the M5450/M5500 push the M5680A against the
wall and use a clamp or a helper to squeeze the bottom
sides of the M5680A so they are tight to the M5450/M5500 like in Step 3.
7. Install the 5669 Tie-Down to the bottom of the M5680A Outdoor Cover using
the four (4) 5582 Sheet Metal Screws (5⁄16” Hex) as shown in the diagram.
Tighten to a maximum torque of 50 in lbs. Then, remove the clamp (if used).
8. Install the six (6) wall mounting fasteners (not provided).