Aircare MAX User manual

MAX DUAL T A N K
Quick Start
FOGGER INSTRUCTIONS
2 Solution
Tanks
POWER
SWITCH
ADJUSTABLE
FOG VALVE
NOTE: Valve assembly features a
chemical resistant VITON SEAL
PRECAUTIONS
Fill Tank
1. Remove cap and fill TANKS with desired
solution.
Each tank will hold 1 gallon of solution.
2. Replace cap securely.
Turn on Power
3. Plug the fogger into a grounded AC socket and turn it
on using the POWER SWITCH, adjust the fog with the
adjustable fog valve.
Miscellaneous
4. No fog will be dispensed until the valve is turned
COUNTERCLOCKWISE.
5. The valve shuts off when the valve is turned CLOCKWISE.
For detailed instructions, please refer to the
User Manual on reverse page.
A Division of D.P.L. Enterprises, Inc.
3868 Post Road, Las Vegas, NV 89120
www.Air-Care.com 800-322-9919
TURN ADJUSTABLE
FOG VALVE TO OFF
BEFORE TURNING
OFF FOGGER
POWER
DO NOT LAY
NOZZLE ON THE
FLOOR, EVEN WITH
THE ADJUSTABLE
FOG VALVE AND
FOGGER MOTOR
TURNED OFF.
P / N MM 0 2 0 8 R ev 5 / 1 4 / 2 0 2 0

MAX DUAL FOGGER
User Manual
Safety
0perating Instructions
• Plug the fogger into a grounded AC socket.
• The Adjustable Fog Valve will regulate
the droplet size and flow. Move the
Adjustable Fog Valve to the position that
provides the smallest volume of fog
needed for the job.
• As the Adjustable Fog Valve is slowly
opened, a fine fog will be generated, and the
volume and droplet size will increase as the
valve is opened farther.
• When the fogger is not being used for an
extended period of time, always shutoff the
valve FULLY then Turn off the motor. Open
the tank cap slightly and relieve the pressure
to avoid leakage of liquid out of the nozzle,
• The Air-Care Max Fogger can retain
pressure in the tank after it has been turned
off. If Adjustable Fog Valve is NOT
TUNRED TO OFF, liquid can be discharged
from the nozzle. Loosen cap and retighten
it to relieve the tank pressure. Turn
Adjustable Fog Valve to OFF.
• If the head of the fogger is stored below the
level of the liquid in the tank AND the
Adjustable Fog Valve is not fully off, liquid
can be siphoned out of the nozzle.
• Always unplug the power cord before
adding or removing solution or water
fromthe tank.
Maintenance
The Air-Care MAX fogger requires a minimum
amount of maintenance. After each use you
should clean the motor air intake filter on the
bottom as it becomes dirty, and rinsing out
the tank, hose, and nozzle at the end of each
workday with clean water and letting the
water wash out residual solution from the
hose and nozzle.
Troubleshooting
Q: Motor does not run.
A: Verify the power cord has the ground pin intact
and is plugged into a grounded out with power
Q: Fogger is running but appears to be clogged.
A: Verify that the washable bottom air filter is
clean.
Q: Fogger is running but no liquid is dispensing
from the tank.
A: Verify there is a minimum of one quart of liquid
in the tank.
For any other issue please contact
Air-Care Tech Support at
800-322-9919
A Division of D.P.L. Enterprises, Inc.
3868 Post Road, Las Vegas, NV 89120
www.Air-Care.com 800-322-9919