AirLive N450R User manual

Q: Firmware is crashed, how to recover N450R?
A: Please refer the followings to u grade firmware again:
1. Un lug the ower of your device.
2. Hold the hardware reset button while lugging the ower.
After 15seconds, the Status LED will flash very fast, lease release the reset button
3. Set your PC's IP address to “Obtain an IP address automatically”. Connect the device’s
LAN ort to your PC.

4. O en your web browser (Recommended browser: IE), then ty e "192.168.123.254".
You will see the emergency function age where you can u load your device’s
firmware.
5. Click “Browse” button to select N450R’s firmware,
and then click “U grade” button to u grade firmware.
6. The rocedure will take about 10 minutes to u grade firmware.
If the rocedure succeeds , the message will show 3 seconds.
Then it will change to original age.

7. Please un lug and re- lug the ower of your device manually.
8. Please wait a while until it boots u (about 1 minute).
Then ress the hardware reset button over 10 seconds to restore it to factory default
setting. After resetting, the device’s IP is 192.168.1.254.
9. O en your web browser, and then ty e "192.168.1.254".
You will get into the web management.