Airwell MAY 110 User manual

Owner’s Manual
High Quality Window Type Room Air Conditioner
MAY 110
RCA INST MANUAL

General Information 1
Name and Function of Components 2
Control Panel 2
Preparations for Operation 3
Cooling Operation 3
Fan Operation 4
Airflow Direction Adjustment 4
Operation, Maintenance and Care 5
Replacing the filter 5
Precautions 6
Before calling for Service 7
CONTENTS
RCA INST MANUAL

To ensure that the air conditioner to be used correctly and safely, please proceed the installation in accordance
with the installation manual and read through this manual carefully before using the system. Please keep the
manual in a safe place after use.
OO
This is window - type cooling air conditioner. The range of working temperature is between 18 C and 43 C.
This air conditioner employ a compact structure and thus has the advantage of small power consumption. It’s
nominal cooling capacity can reach 3,200W. However, the cooling efficiency of a window - type air conditioner
depends on many factors, forexample its orientation, the indoor room temperature, frequency of opening and
closing door, insulation of building, height of ceiling etc...
The common filter installed under the front frame at the factory can be reused after cleaning and drying.
However, the electrostatic filter most recently developed by 3M is recommended. This electrostatic filter can
filter not only filter airborne dust in the air, but also flower pollen, bacteria, nicotine, acarus and other harmful
airborne substances. This greatly increased the degree of air cleanness.
To prevent accidents, make sure to install a fuse for the external power supply of the air conditioner. The fuse
should have a rated capacity of 10A. External power supply of the unit should be wired in accordance with the
related national standards. To prevent fire and accidents, extension cords should not be used.
The maximum input power and electric current specified on the label are values under the following extreme
O
circumstances: outdoor temperature of 43 C and voltage of 230V. Under normal circumstances, the output
power and electric current are approximately the values specified on the label.
Noise level specified on the label is the value measured in the Noise Measurement Room at the factory.
The water-proof level specified on the label is outdoor IPX4. The IXP4 test was conducted to the outside of
the air conditioner under the following conditions: the air conditioner is physically installed; the front cover of
the unit is outside the wall, the space between the wall and the front cover and front cover is firmly sealed.
1
GENERAL INFORMATION
RCA INST MANUAL

SELECTOR
Hi Cool
Lo Cool
Hi Fan
Lo Fan
Off
2
Ventilation Control
When the slide level is set at the Left (position of Off),
the ventilation door will close. Then the indoor air
can only be circulated and adjusted. Set the slide
lever to the position of On at the right, and the
ventilation door will open and the air, fog and odour
can be discharged out of the room.
Function Control switch
Offl Stop all operation
Lo Fan Fan only operation. Air delivery at low speed.
Hi Fan Fan only operation. Air delivery at high speed.
Lo Cool Cooling operation at low speed.
Hi Cool Cooling operation at high speed.
CONTROL PANEL
NAME AND FUNCTION OF COMPONENTS
Air Outlet Grille
Power Cord Plug
Intake Grille Air Filter Pannel
Auto Swing Switch
Thermostat
When you adjust the thermostat to the desired position,
it will automatically control the temperature of indoor air.
The temperature of the indoor air will become lower
with each turn clockwise.
RCA INST MANUAL

Set the function control switch to “Off”.
Insert the power plug, and turn on the power of the unit.
Turn the temperature control switch to position to “10” (the coolest)
and make preparations for other operations.
3
High Cool
Turn the function selector switch to “Hi Cool” then the unit automatically conducts
the high cool operation, so that the room temperature is reduced rapidly and at
the same time the room is being dehumidified and dust is being filtered.
Low Cool
Turn the function selector switch to “Low Cool” and the unit automatically
conducts calm cooling operation and eliminate dust from the room.
Temperature Adjustment
After turning on the unit, adjust the temperature controller when the room
temperature reduces to the point you desire. Slowly turn the knob from the
coolest point “10”. The compressor will stop operating when a “click” sound is
heard, indicating that further cooling will stop. The temperature controller
automatically turns on the unit for cooling after the room temperature has
gradually increased, and the temperature controller turns off the cooling
operation when the room temperature reduces to that you choose.
Note:
O
Adjust the temperature controller until you feel comfortable (normally 26 - 30 C).
After the temperature controller is adjusted, remember that the temperature control
knob can not be adjusted clockwise within 3 minutes, otherwise the compressor
will be burnt out.
PREPARATIONS FOR OPERATION
COOLING OPERATIONCOOLING OPERATION
SELECTOR
Hi Cool
Lo Cool
Hi Fan
Lo Fan
Off
THERMOSTAT
SELECTOR
Hi Cool
Lo Cool
Hi Fan
Lo Fan
Off
1
Cool
THERMOSTAT
SELECTOR
Hi Cool
Lo Cool
Hi Fan
Lo Fan
Off
2
3
4
56
7
8
9
10
RCA INST MANUAL

4
The air outlets at the right of the unit can be adjusted in four directions. Please select the best wind direction you need.
High Fan
Turn the function switch to “Hi Fan”.
At this time the fan will operation in high speed, and the compressor will stop
operation except for the ventilation of the room and eliminate dust.
Low Fan
Turn the function switch to “Lo Fan”.
At this time the fan operation in low speed, and the compressor will stop
operation except that the slight wind ventilate the air and eliminate dust.
Adjust the horizontal grille.
Move the adjustment plate to direct the air flow up,
down, or forward.
SELECTOR
Hi Cool
Lo Cool
Hi Fan
Lo Fan
Off
FAN OPERATION
AIRFLOW DIRECTION ADJUSTMENT
SELECTOR
Hi Cool
Lo Cool
Hi Fan
Lo Fan
Off
Set the auto swing at the position of “ON”.
The vertical grille automatically swings to the left or
right.
In order to obtain the single fixed direction, set the
switch at “ON”.
Set the switch to “OFF” when desired air flow
direction is obtained.
RCA INST MANUAL

5
If you installed an ultra - strong electrostatic filter in the air
conditioner, you should replace it periodically in accordance with
the actual condition of use. Water washing is not allowed. Users
are recommended to check the filter every three months to
determine if it should be replaced. Under normal conditions, a
filter cam last for six months. The filter can be replaced as follows:
Draw the filter to the right, take it out carefully and replace it with a
new one at the same position with side marked “FRONT” facing
outwards.
Note:. The filter must be purchased from authorized dealer. Note
that the model number in the package of the filter must conform to
that you use.
Remember the following suggestions so as to improve the cooling efficiency of the unit , to reduce noise
and save electricity costs.
Pull the curtains close. Direct sunlight reduces the cooling efficiency of
the air conditioners . So the curtain must be pull close
Do not install near a heat source. Do not use heating device near the air
conditioner, otherwise the cooling efficiency will reduce and the plastic panel
may deform.
Do not block the air inlets and outlets. Do not hang clothes or any other objects
near air inlets and outlets.
OPERATION, MAINTENANCE AND CARE
REPLACE THE FILTER
RCA INST MANUAL

6
The air conditioner must operate in the supply circuit with standard power supply (voltage 230V and frequency 50Hz)
and only the fuse with designated capacity is allowed for use. Metal wires are forbidden to replace it. The fuse is that in
the power supply circuit should be rated 10A.
The drain outlet is set in the back at the bottom left of the body. Please select a correct draining method in accordance
with the installation manual. Please turn off the air-conditioner, turn off the power and inform the service center
immediately in the following cases.
When abnormal circumstances occur in the air-conditioner,
the switch does not operate as usual,
the power plug and the lead are overheating during the unit’s operation,
if the outer covering of the wire is damaged,
if foreign objects enter into the air-conditioner,
If the water suddenly splashed on the air conditioner.
No slim poles or other similar objects should be stuck into air inlet or
outlet grill when the air conditioner is in operation.
When cleaning the air conditioner, do not sprinkle water on
the unit.
When turn off the air conditioner, do not directly pull out the power
plug, use the power switch.
If the supply cord is damaged must contact the
manufacturer or his authorized service claimant for
repair, as special purpose tools are required.
PRECAUTIONS
SPECIAL NOTE
Do not restart the unit until the unit has stopped
for three minutes (due to turning off the unit or
power cut.)If not the compressor will be easily
burnt out.
RCA INST MANUAL

7
Check the listed conditions in the followings. Perhaps you may find the solutions for the problems and save time and
money as well.
Not operating
Is the power cord connected to the power source?
Is the circuit breaker or fuse open or broken?
- Close the circuit breaker again or replace the fuse.
Is the power cut off?
- Turn on a lamp switch to see if it can light up so as to confirm.
No cool air or insufficient cool air
Is there any error on the indicated temperature setting?
Is the indicated set temperature higher than the room temperature?
- Reset the indicated set temperature.
Does the sun shine directly into the room?
- Shade the sunlight with window curtain, etc.
Is the door or window open?
- Close the entrance, exit of the window.
Are there any obstacles blocking the ventilation of the air inlet or outlet of the air conditioner?
- Remove the obstacles.
Has the extractor fan in the room been continuously operating?
Is the air filter blocked?
- Replace the filter.
Is the air exhaust button in the open position?
- Close the air exhaust door
Correct installation mat reduce vibration and noise.
This unit produces lower noise, but incorrect installation (especially when the unit is directly installed on the glass
window) may result in larger vibration noise. Therefore, we recommend that the installation of this unit be conducted by
the special air conditioner installation team, in accordance with the installation manual we provide with the product.
PRIOR TO CALLING FOR SERVICE
RCA INST MANUAL

TECHNICAL ENQUIRIES SERVICE / WARRANTY
1800 1800 04 1300 553 000
MELBOURNE
745 Springvale Road
Mulgrave VIC 3170
TEL: [phone] FAX: [phone]
SYDNEY
CNR Marion St & Airport Ave
(P.O. Box. VQ)Banktown
Airport NSW 2200
TEL: [phone] FAX: [phone]
BRISBANE
Unit 9, 123 Muriel Ave
Moorooka QLD 4105
TEL: [phone] FAX: [phone]
ADELAIDE
Offices on the parkSuite 27, 8
Greenhill Road
Wayville SA 5034
TEL: [phone] FAX: [phone]
PERTH
Suite 23, 350 Cambridge St
Wembley WA 6014
TEL: [phone] FAX: [phone]
NEWCASTLE
Suite 3, 19 Darby Street
Newcastle NSW 2300
TEL: [phone] FAX: [phone]
NEW ZEALAND
517A Rosebank Road
Avondale, Auckland NZ TEL: [phone] FAX: [phone]
www.airwell.com.au
NZ Tech Support Freecall
TEL: [phone]
WITH A CONCERN FOR A CONSTANT IMPROVEMENT, OUR PRODUCTS CAN BE MODIFIED WITHOUT NOTICE. PHOTOS NON CONTRACTUAL. © Copyright 2003
RCA INST MANUAL