AIS RS-109M User manual

AIS Net Locator operating
instructions
Unpacking and inspection
Please unpack the product properly and take an
inventory of the accessories according to the
table below. It is recommended that you keep the
box and packaging materials.
Item Count Item Count
Net Locator 1 Manual 1
Power adapter 1
Main features
•GPS/Bei ou dual-mode precise
positioning, with the possibility of
displaying the position of the Net Locator
on the AIS receiver
•isplay of the Net Locator's power status
on the AIS receiver
• AIS signal transmission interval
configurable: 0.5 minutes - 10 minutes
•Waterproof rating: IPX7.
•Can work continuously for more than 15
days on one charge (transmitting interval
set to 3 minutes)
•Easy bundling and convenient operation
for switching on and off
Overview
1. Built-in antenna
2. Transparent bottom cover
3. Programming interface
4. Charging port
5. Power switch
6. Charging indicator (red
and yellow)
7. Working light (red and
green)
Notes
The programming interface is used to set the
ship name, MMSI code, transmit interval time, call
sign and other extended information. To be set by
the dealer only.
No attempt should be made to remove the panel
of the Net Locator as this will cause a leak!
Charging the battery
Before use, the battery should be charged.
Plug the power adapter into the AC power output
socket.
Unscrew the transparent bottom cover on the
underside of the Net Locator.
Remove the plug of the charging port on the
panel of the Net Locator and plug the output
terminal of the power adapter into the charging
port to start charging.
When the battery is fully charged, the yellow light
will be illuminated. Charging time is approximately
4 to 5 hours.
After charging, the transparent bottom cover
should be screwed on tightly to ensure water
resistance.
Notes
When charging, please turn the power switch to
OFF (power off).
o not short-circuit the charging connector.
Use a dedicated power adapter ( C 9.2V / 1A
output), otherwise the unit may be damaged.

Switching on and off
Power on:
Turn the power switch to the ON position, the red
and green lights will illuminate for 2 seconds and
then turn off to enter normal operation.
Power off:
Turn the power switch to the OFF position to enter
the power off state.
Description of the indicators
Indicator lights Status Descripon
Green light Fast flashing GPS in position,
battery above
7.0V.
Slow flashing GPS in position,
battery below
7.0V.
Please take
care to
recharge the
device in time.
Red light AIS
transmission
Green + Red Simultaneous
illumination
Power-on
initialisation
Main technica specifications
Transmit power 5W
Operating time > 360 hours
Lithium-ion battery ( C7.4V) 3000mAh
Weight (with battery) 336g
Frequency range 161.975MHz;
162.025MHz
Frequency stability ±0.5ppm
Operating temperature -20°C – +60°C
GPS/Bei ou update interval 30s – 10min
(configurable)
External dimensions
(L*W*H)
330mm * 74mm *
65mm
Transmit frequency bias 1.8kHz
Frequency interval 25kHz
Baud rate 9600bps (GMSK)
Caution
•If the GPS green light is flashing and the
positioning status lasts for more than 90
seconds, the GPS is working abnormally.
Please check whether the GPS reception
signal in your environment is affected by
obstructions, such as for example, if the
Net Locator is placed indoors.
•If the transmitting interval is longer, the
standby time of the unit can be increased.
This can be set by the user on request by
contacting the dealer.
•Take care when tightening the transparent
bottom cover.
•If you find that the silicone waterproof ring
is old or damaged, please contact your
dealer for a replacement.
Insta ation diagram
The height of the Net Locator
above the water is ~1m
Bamboo pole
Fishing net
Heavy object, fasten tightly
Buoys
Buoys
Knot and tie tightly
Use holes to tie
Net Locator to
bamboo pole