Akiles ProLam R27 User manual

13
SOLUTION: The laminating temperature is too low; there is not
enough heat to melt the adhesive. Increase the laminating
temperature.
PROBLEM: The laminated material seems to have an irregular
surface that does not match the texture of the paper being coated.
SOLUTION: This is usually caused by adhesive build-up or dirt
on the rubber rollers. Inspect the rubber rollers and clean as
cessary . Damage to the rubber can also cause irregularities
in the surface of the film.
PROBLEM: General haziness or cloudiness in the film after
lamination.
SOLUTION: Increase the temperature or decrease the speed.
That cloudiness is a function of incomplete adhesion. On a variable
speed machine loaded with thicker film, it may be that the film is
being run too fast.
Warm Up Time 20 min
Adjustable Temperature 320°F Max
Laminating Speed 9 settings (Up to 3.6 ft / min)
Max Film Thickness 10 mil
Max Film Width 27"
Max Laminating Thickness 1 mm
Core Size 1"
Heated Roller Size 2.17" (55 mm)
Sleep Mode Yes, after 2 hours
Reverse Switch Yes
Machine Dimensions 36.25" W x 12" H x 16" D
Weight 93 lbs
Power Consumption 1250 watts, 11.4amp
Warranty 1 Year
SPECIFICATIONS