Alcatel-Lucent OmniAccess AP80 User manual

The Alcatel-Lucent OmniAccess AP80M is the ideal wireless solution for harsh outdoor environments where conven-
tional Wi-Fi access points cannot be deployed. The OmniAccess AP80M is a dual-radio 802.11a/b/g access point that
also supports wireless air monitoring capability. Designed for extreme, all-weather deployment (such as extreme heat,
cold, rain), the OmniAccess AP80M operates as a “thin” AP, fully controlled and managed by an OmniAccess WLAN
switch. The OmniAccess AP80M’s flexible design supports a variety of attachable antennas and supports an integrated
PPP over Ethernet client for remote deployments over service provider networks.
Network Configuration
• Wireless access point (802.11a/b/g)
• Air monitor (802.11a/b/g)
Antennas
• None. External N-type antenna interfaces
provided (see Electrical Enterfaces section)
Radio Specs - 5GHZ - IEEE 802.11a
• Frequency bands supported
¬ 5.150 ~ 5.250 GHz (low band),
country specific
¬ 5.250 ~ 5.350 GHz (mid band),
country specific
¬ 5.470 ~ 5.725 GHz (Europe), country specific
¬ 5.725 ~ 5.825/5.850 GHz (high band),
country specific
• Radio technology: orthogonal frequency
division multiplexing (OFDM)• Modulation
type – BPSK, QPSK, 16-QAM, 64-QAM
• Transmit power – configurable by system
administrator/professional installer
• MAC – CSMA/CA with ACK
• Operating channels:
¬ US, Canada - 13
¬ ETSI - up to 19
¬ Japan - disabled
• Data rates: 6, 9, 12, 18, 24, 36, 48, 54
Mbps per channel
• Radio band selectable via software
• Multi-mode radio band 802.11a or 802.11b/g
selectable via software
Radio Specs – 2.4GHZ - IEEE 802.11b
• Frequency bands supported
¬ 2.400 ~ 2.4835/2.497 GHz, channels
country specific
• Radio technology – direct sequence spread
spectrum (DSSS)
• Modulation type – CCK, BPSK, QPSK
• Transmit power – configurable by system
administrator
• MAC – CSMA/CA with ACK
• Operating channels:
¬ US, Canada - 11
¬ ETSI – up to 13
¬ Japan - 14
• Data rates: 1, 2, 5.5, 11 Mbps per channel
• Radio band selectable via software
• Multi-mode radio band 802.11a or 802.11b/g
selectable via software
Radio Specs – 2.4GHZ - IEEE 802.11g
• Frequency bands supported
¬ 2.400 ~ 2.4835 GHz, channels country specific
• Radio technology: orthogonal frequency
division multiplexing (OFDM)
• Modulation type – BPSK, QPSK, 16-QAM,
64-QAM
• Transmit power – configurable by system
administrator
• MAC – CSMA/CA with ACK
• Operating channels:
¬ US, Canada - 11
¬ ETSI – up to 13
¬ Japan - 13
TECHNICAL SPECIFICATIONS
Alcatel-Lucent OmniAccess AP80
DUAL-RADIO 802.11A/B/G ACCESS POINT

www.alcatel-lucent.com
Alcatel, Lucent, Alcatel-Lucent and the Alcatel-Lucent logo are trademarks of Alcatel-Lucent. All other
trademarks are the property of their respective owners. Alcatel-Lucent assumes no responsibility for the
accuracy of the information presented, which is subject to change without notice.
© 2007 Alcatel-Lucent. All rights reserved. P/N 031883-00 Rev. E 8/07
ORDERING INFORMATION
PART NUMBER DESCRIPTION
OAW-AP80M Alcatel-Lucent OAW-AP80M outdoor wireless access point. Includes one OAW-AP80M (simultaneous 802.11 “A”+ “B/G”) with dual N-type
detachable antenna interfaces (1 x 2.4Ghz band and 1 x 5Ghz band), 1 x 10/100 BaseT (8Pin DIN) Ethernet interface (supports high power-
over-Ethernet, integral power lightening arrester and ground point), 1 x RSSI DC alignment interface, pole / mast mounting hardware and
Installation Guide. Also includes: indoor use only auto-sensing 110/240VAC to 48VDC power-over-Ethernet injector suitable for use with the
OAW-AP80M wireless access points and 100 foot outdoor Ethernet cable (8Pin DIN to 10/100BaseT RJ-45). External antennas and antenna
lightning arrestor shall be purchased separately.
OAW-AP-LAR-1 Outdoor antenna lightning arrestor. Lightning surge arrestor for the OAW-AP80 access point: Single, in-line lightening arrester with N-type
male to N-type female interface. Supports RF frequency pass through of 2Ghz – 6Ghz.
External antenna: Alcatel-Lucent offers a wide variety of outdoor rated detachable antenna types certified for use with the OmniAccess AP80M. Please contact your
local sales representative for details.
• Data rates: 6, 9, 12, 18, 24, 36,
48, 54 Mbps per channel
• Radio band selectable via
software
• Multi-mode radio band 802.11a
or 802.11b/g selectable via
software
Manageability
• Management of all 802.11
parameters as AP
• Network-wide AP management
via:
¬ CLI
¬ Web GUI
¬ SNMP
• Access point profiles
• Management by:
¬ Geographical location
¬ BSSID
¬ Radio type
• Encryption support (AP and
WLAN switch)
¬ 40-bit / 64-bit / 128-bit / 152-
bit WEP, TKIP, AES, WPA, WPA2
Interfaces-Electrical
• 1 x 10/100 Base-TX auto-sensing
Ethernet interface (IP67 8-pin
male (pole) M12 circular DIN
connector (Au) contacts):
¬ Auto-sensing MDI/MDX
¬ PoE 48V DC / 1.2A (30W)
power over Ethernet (non-
standard 802.3af)
¬ Integral lightning arrester
• 1 x 2.4 Ghz N-type female
antenna Interface
• 1 x 5 Ghz N-type female anten-
na Interface
• 1 x electrical ground / safety
terminal
• 1 x Integral ENET lightening
arrester
Power Adapter Interfaces
Access point (AP) port
• 1 x 10/100 Base-TX auto-sensing
Ethernet (RJ-45) network (AP)
interface:
¬ Auto-sensing MDI/MDX
¬ PoE 48V DC / 1.2A power over
Ethernet (non-standard 802.3af)
Network (ENET) Port
• 1 x 10/100 Base-TX auto-sens-
ing Ethernet (RJ-45) network
(ENET), auto-sensing MDI/MDX
Ethernet interface supplied with
8-Pin DIN to RJ-45 CAT-5 shield-
ed Ethernet cable (164 ft / 50 m)
Interfaces-Mechanical
• 4 x mounting bracket points
• Ruggedized pole or mast mount
hardware provided
(articulating in horizontal and
vertical planes)
• Ruggedized wall mount hard-
ware as an available option.
Visual Indicators (LEDS)
• (Ready) power on/off (provided
on power Injector)
Power Requirements
• Access point power draw - 48V
DC / 1.2A (30W) power-over-
Ethernet (non-standard 802.3af)
• External power injector, auto-
sensing 100-240V AC Input,
1.5A output 48 VDC, 1.2A
(30W) (provided)
Device Dimensions H/W/D
• 7.80 x 7.80 x 2.76in. (198 x 198
x 70mm)
• Weight - 3.53Ibs (1.6Kilo)
Shipping Dimensions
H/W/D
• 19.7 x 11.8 x 6.7in. (500 x 300 x
170mm)
• Gross weight - 13.22lbs (6Kilos)
Environmental
• Temperature
¬ Operating: -22 to 131 ºF (-30
to 55 ºC)
¬ Storage: -40 to 176 ºF (-40 to
80 ºC)
• Humidity 0% - 95% (non-con-
densing)
• Survival wind speed: 201Km/hr /
125mph
External Power Adapter
• Temperature
¬ Operating: 32 to 140 ºF (0 to
60 ºC)
¬ Storage: -58 to 158 ºF (-50 to
70 ºC)
• Humidity 0% - 95% (non-con-
densing)
Mounting Options
• Pole or mast mount
(hardware included)
• Wall mount (optional hardware)
Standards
• Ethernet IEEE 802.3 / IEEE
802.3u
• Wireless IEEE 802.11a/b/g
• PPP over Ethernet RFC2516
Radio Approvals
• FCC DOC Part 15 Class B
(digital portion)
• FCC Part 15 subpart C 15.247
• FCC Part 15 subpart E 15.407
• ICES-003 Class B
• RSS 210 (Canada)
• VCCI Class B (Japan)
• Telec 2.4, Channel 14 and 5 GHz
approved (Japan)
• CE marked with NB letter of
opinion for RTTE
¬ ETS 300 328 2.4 GHz
¬ ETS 301 893 5.4 GHz
¬ ETS 301 489 EMC
• MIC Korea
• SRRC (China)
• AS/NZS 3548 Class B
• AS/NZS4771 (C-tick)
Safety Approvals
• cULus listed
• PSE Mark (AC power supply)
• IEC 60950 CB certificate and
report
• UL Listed (UL60950)
• UL Listed (Canadian Electrical
Code/CSA 22.2 No. 60950)
• EN60950 / IEC60950