Alen BreatheSmart User manual

1
www.AlenCorp.com 1-800-630-2396
USER MANUAL
®TM

2 3
www.AlenCorp.com 1-800-630-2396
Helping People Live Better
TABLE OF CONTENTS
Operating Your Unit
Care & Maintenance
Replacing The Filter
Why You Should Replace Your Filter
AutoShip
How To Replace The Filter
Troubleshooting Tips
4
4
7
7
10
10

4 5
www.AlenCorp.com 1-800-630-2396
Helping People Live Better
AIR PURIFIER SAFETY
Provided in this manual are important safety messages regarding your electrical home appliance.
Always read, follow, and save all safety directions.
Location Requirements
Use a level surface at least 6” (15.2cm) from heat sources such as ranges or heaters.
Operate indoors only.
Electrical and Safety Requirements —
-
WARNING! To reduce the risk of electric shock, this equipment has a polarized plug (one
nel to install the proper outlet. Do not alter the plug in any way
.
Do not connect unit to any electrical socket that is damaged.
Do not use next to a source of heat, such as a range, heater or dryer.
Do not use near a bath, shower, swimming pool or where a unit can get wet.
Do not use in a window.
Do not use an adapter.
Do not use an extension cord.
Do not exceed the rating of the power outlet or connection device. May cause electric shock
Do not insert or pull out plug with wet hands, it may cause electric shock.
Never try to take apart or repair the unit by yourself.
Disconnect the power if strange sounds, smell or smoke comes from it.
Do not drop the unit, as this can result in damage.
Do not place heavy objects on the power cord and take care so that the cord is not com-
Do not climb up or sit on the unit. You may be injured if you fall or if the unit falls over.
Use only in the proper electrical socket type. Socket type (voltage & hertz) can be found
on the product sticker on the side or bottom of the unit. Plugging the unit in to the incorrect
socket type can damage/destroy the unit.
USING YOUR AIR PURIFIER
Operating Your Unit:
1.
2.
lights will light up. To turn off the lights on your unit, press the Power Button. To turn
3. The Colored Light around the Power Button indicates the air quality being measured
by the particle sensor.
4. Press ION to activate the ozone safe ionizer. Activation of ION enhances your unit’s ability
to remove airborne particles (similar to the way dust is attracted to a TV screen). Press
ION again to turn off.
5. FILTER LIFE Indicator — The Filter Life indicator has 3 lights: Green, Yellow and Red.
. The Yellow light will
6.
will be reset to Green.
7.
before turning off.
8. Press SPEED and watch the indicator lights until desired fan speed is achieved. Most
you suspect the air is particularly dirty, you should set the speed to T (Turbo).
9. Press AUTO to set the unit on Automatic Mode. Automatic Mode will use the SmartSen-
sor Technology to adjust the speed of the unit depending on the amount of particles
present in the air.
Color Meaning
Blue Low quantity of airborne particles detected
Yellow Moderate quantity of airborne particles detected
Red

6 7
www.AlenCorp.com 1-800-630-2396
Helping People Live Better
Features
CARE & MAINTENANCE
Replacing The Filter
-
®
Control panel
Side air intake grill
Rating label
hour timer to control air
circulation.
Bottom air intake grill
green.

8 9
www.AlenCorp.com 1-800-630-2396
Helping People Live Better
Why You Should Replace Your Filter
-
quired to be changed on a regular basis in order to prevent excessive stress on the unit.
Alen’s AutoShip f ilter Plan — Convenience, Pure Air and Savings
usage. With Alen’s convenient AutoShip
your door, exactly when needed.
Save —
Convenience —
Choose your desired monthly frequency and cancel at anytime.
Lifetime Limited Warranty — An Alen Auto Ship plan is the convenient way to extend the
How To Replace The Filter
1.
2.
Pre-Filter attached with Velcro®.
3. .
How To Clean The SmartSensor
The SmartSensor uses an infrared light to detect airborne particles. After prolonged periods
of use, dust can accumulate on the glass lens and affect the sensitivity of the sensor. If this
occurs, your unit will run on the highest speeds when set in Automatic mode and will not come
unit off. Wet the end of a cotton swab with water and wipe the lens with it. Dry the lens with the
other end of the cotton swab. For best performance, clean the SmartSensor lens each time you
1. With the unit standing upright,
pull out the lower left or right
corner of the front cover.
2. After pulling out, lift the cover
away from the unit.
3.
by pulling out on the pull
strings. Place the used
-
vent dust from re-entering
the air.
4.
the plastic bag and insert it
into the air cleaner with the
pull strings facing outward.
5. Insert the top tabs of the
the lower part of the cover
will snap into place.
WARNING! RISK OF ELECTRIC SHOCK - These servicing instructions are for use by

10 11
www.AlenCorp.com 1-800-630-2396
Helping People Live Better
TROUBLESHOOTING TIPS
®
-
mance.
-
-
the motor.
-
-
CHANTABILITY AND FITNESS FOR A PARTICULAR USE OR PURPOSE. ALEN’S SOLE LIABILITY WITH
OF OR RELATING TO THE AIR PURIFIER OR ITS USE BY ANY PERSON.
STATE.

12 Helping People Live Better
BreatheSmart-pm-7-2012
Table of contents
Other Alen Air Cleaner manuals

Alen
Alen T500 User manual

Alen
Alen A350 User manual

Alen
Alen Paralda User manual

Alen
Alen KJ25FE-H1 User manual

Alen
Alen A350 User manual

Alen
Alen T500 User manual

Alen
Alen BreatheSmart 45i User manual

Alen
Alen BreatheSmart 75i User manual

Alen
Alen BreatheSmart FLEX User manual

Alen
Alen BreatheSmart FIT50 User manual