Alfaled AFP-F1 User manual

●Apply to single color, dual color or RGB/ RGBW LED controller.
●Each remote can match one or more receiver.
●CR2032 battery powered.
●Removeable and stick anyw here easily, or mount on wall use panel base.
Model No.: AFP-F1, AFP-F1-2, AFP-F2, AFP-F3
Features
4-key panel/ 1-4 color/ W ireless remote 30m distance/ CR2032 battery
4-Key Panel RF Remote Controller
AFP-F1 AFP-F2 AFP-F3
Technical Parameters
Input and Output
W arranty
5 years
W arranty
Operation temperature
Case temperature (Max.)
Environment
IP20
IP rating
Ta: -30
O
C ~+55
O
C
Tc: +85
O
C
Output signal RF 2.4 GHz( )
W orking voltage 3VDC CR203 2( )
W orking current ＜5mA
Standby current ＜2μA
Standby time 2 years
Remote distance 30m
S af ety a nd EM C
EMC standard (EMC) EN301 489,EN 62479
Radio Equipment(RED) EN300 328
Certification CE,EMC,LVD,RED
EN60950
Safety standard(LVD)
LVD RED
1 Zone Dimming 1 Zone CCT 1 Zone RGB/ RGBW
AFP-F1-2
2 Zone Dimming
User Manual Ver 1.0.2 www.alfaled.sk Page 1

M echa nica l S tructures and Insta llations
AFP-F1, AFP-F1-2, AFP-F2, AFP-F3 4-Key Panel RF Remote Controller
To fix the panel, two options are offered for selection:
Option 1: fix it on the wall with two screws.
Option 2: adhere it to the wall with paster.
Replace batter y :
Note: Before the first use,
please remove the protective
film on the battery.
C 2032 BatteryR
Typical base as below :
European style 86 siz e
Baseplate Base
Installation diagram:
panel border
50.00 mm
50.00 mm
12.00 mm
50.00 mm
86.00 mm
14.00 mm
86.00 mm
86.00 mm
User Manual Ver 1.0.2 www.alfaled.sk Page 2

● AFP-F2 Color temperature remote
●AFP-F3 RGB / RGBW remote
On/ Off: Turn on or off light.
Brightness: Adjust brightness.
Short press 10 levels,
long press for continuous 256 levels adjustment.
Color temperature+/ -: Adjust color temperature.
Short press 11 levels,
long press 1-6s for continuous 256 levels adjustment.
COn/ Off
Color
Mode Speed/ Saturation
WW
CW
Color
temperature + On/ Off
Brightness
Color
temperature -
On/ Off: Short press turn on or off light,
long press 1-6s to adjust brightness continuously.
Mode: Change dynamic mode.
Short press run next mode, long press 2s run mode-cycle.
●AFP-F1 Single color dimming remote
●AFP-F1-2 2-zone single color dimming remote
On/ Off: Turn on or off light.
Brightness+/ -:Adjust brightness.
Short press 10 levels,
long press 1-6s for continuous 256 levels adjustment.
Scene: Brightness memory.
Short press recall the scene,
long press 2s save the current brightness into the scene.
On/ Off
Brightness +
Brightness - Scene
Zone1 on
Zone1 off
Zone2 on
Zone2 off
Zone 1 2 on-:
Short press turn on zone light,
long press 1-6s to increase brightness continuously.
Zone 1 2 off:-
Short press turn off zone light,
long press 1-6s to decrease brightness continuously.
Key function
AFP-F1, AFP-F1-2, AFP-F2, AFP-F3 4-Key Panel RF Remote Controller
User Manual Ver 1.0.2 www.alfaled.sk Page 3

S afety information
1. Read all instructions carefully before you begin this installation.
2. W hen installing battery, pay attention to the battery positive and negative polarity.
A long time w ithout the remote control, remove the battery.
W hen remote distance becomes smaller and insensitive, replace the battery.
3. If no response from the receiver, please re-match the remote.
4. Gently handle remote, beware of falling.
5. For indoor and dry location use only.
Match Remote Control (two match ways)
Use the controller’s Match key
Match:
Short press match key, immediately press on/ off
key of the remote.
Use Pow er Restart
Match:
Switch off the power, then switch on power again,
immediately short press on/ off key 3 times on the remote.
The light blinks 3 times means match is successful.
Delete:
Switch off the power, then switch on power again,
immediately short press on/ off key 5 times on the remote.
The light blinks 5 times means all matched remotes were
deleted.
Delete:
Press and hold match key for 5s to delete all match,
The light blinks 5 times means all matched remotes
were deleted.
End user can choose the suitable match/ delete w ay s. Tw o options are offered for selection:
Color: Change static RGB color.
Short press get 24 kinds static color, long press for continuous static color adjustment.
1
R 100%
9
G 100%
21
R 100%
B 100%
17
B 100%
25(1)
R 100%
5
R 100%
G 100%
13
G 100%
B 100%
Speed / Saturation:
For dynamic mode, adjust speed.
Short press 10 levels, long press 2s get the default speed.
For static color, adjust saturation, namely change current static color to mixed white slowly.
Short press 11 levels, long press 1-6s for continuous 256 levels adjustment.
RGBW light:
long press Mode +Speed/ Saturation key to adjust W channel brightness simultaneously.
AFP-F1, AFP-F1-2, AFP-F2, AFP-F3 4-Key Panel RF Remote Controller
User Manual Ver 1.0.2 www.alfaled.sk Page 4