Match Remote Control (two match ways)
Use the controller’s Match key
Match:
Short press match key, immediately press on/ off
key (single zone remote) or zone key (multiple zone
remote) of the remote.
Use Pow er Restart
Match:
Switch off the power, then switch on power again,
immediately short press on/ off key 3 times on the remote.
The light blinks 3 times means match is successful.
.
Delete:
Switch off the power, then switch on power again,
immediately short press on/ off key 5 times on the remote.
The light blinks 5 times means all matched remotes were
deleted.
Delete:
Press and hold match key for 5s to delete all match,
The light blinks 5 times means all matched remotes
were deleted.
End user can choose the suitable match/ delete w ay s. Tw o options are offered for selection:
AFR-1-1 One-key RF Remote Controller
43.00 mm
17.00 mm
S afety information
1.Read all instructions carefully before y ou begin this installation.
2.W hen installing battery, pay attention to the battery positive and negative polarity.
A long time w ithout the remote control, remove the battery.
W hen remote distance becomes smaller and insensitive, replace the battery.
3. If no response from the receiver, please re-match the remote.
4.Gently handle remote, bew are of falling.
5. For indoor and dry location use only.
CR2032 Battery
Note: Before the first use,
please remove the protective film on the battery.
LED indicator
Click to turn on/ off,
Press and hold 1-6s to increase/
decrease brightness.
Back holder with magnet
Mechanical Structures and Installations
26.50 mm
To fix the remote, three options are offered for selection:
Option 1: stuck on any metal surfaces directly.
Option 2: fix it on the wall with two screws .
Option 3: adhere it to the wall with 3M paster.
User Manual Ver 1.0.4 www.alfaled.sk Page 2
