Alicn Medical AET-R161 User manual
Alicn Medical (Shenzhen), Inc.
Instruction manual
Non-contact infrared thermometer
Model: AET-R161
This equipment supports Bluetooth connect mobile terminals
Thank you for choosing our Non-contact infrared thermometer, type AET-R161. Please read this
manual before use.
Product information
Name: Non-contact infrared thermometer
Mode: AET-R161
Manufacturer: Alicn Medical (Shenzhen), Inc.
Address: 4/F, No.5 Building, 2nd Section BaiWangxin Hi-Tech Park, Xili, Nanshan District,
Shenzhen City, China
Website: http://www.alicn.com
Caution
1. The device complies with RF specifications when the device used at 0mm form your body. This
product can be used across EU member states.
2. This thermometer is calibrated at the time of manufactured, if the thermometer is use according
to the instruction, periodic recalibration is not required. Do not scratch the probe, or may cause
inaccuracy.
3. This thermometer is intended for household and clinic use.
4. Remove the batteries if the thermometer is not going to be used for long period time.
5. This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Alicn Medical (Shenzhen), Inc.
RF Exposure
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This device should be installed and operated with minimum distance 0mm between
the radiator & your body.
Recommendations
Don’t use this product for other purposes
Children less than 11years use this unit must be accompanied by adult
It is not waterproof device. Clean it only with damped cloth gently
It is forbidden to leave the product exposed to any chemical solvent, direct sunlight or high
temperature
Do not drop, tramp or impose any vibration or impact on the product
If you are not going to use this thermometer for a long period of time Please take out the batteries
When dealing with disused battery, please refer to the native laws and environment regulations
Unit description
LCD Display
Probe
LCD
On/Off Button
Unit Body
Mode Switch Button
Battery cover
Start Button
Environmental objects temperature mode
Temperatur
e
Memory indication
Forehead mode
Unit
Battery
Alicn Medical (Shenzhen), Inc.
Load and replace the battery
When the low voltage symbol “ ” is flashing, replace the battery immediately. The steps
showed as follows:
Press the cover of the battery, and push it down, then the battery cover is pushed away
Place two AAA batteries according to the current negative pole
Close the battery cover
Directions for use
Before measuring, you need to notice:
1. Recommend try it out before formal measurement, so as to operation this thermometer
familiarly.
2. Don’t expose the thermometer to temperature extremes (below-20℃/4℉, or over 50℃/122℉)
or humidity extremes (below 15%RH or over 95%RH).Please place the thermometer in the
temperature range 16℃~35℃at least rest 30 minutes before start measuring, failing to do
may cause inaccuracy
3. Don’ t use the thermometer under temperature extremes (below 0℃/32℉or over
100℃/212℉)or humidity extremes (below 15%RH or over 85%RH )
4. The user should stay indoors at least 20 minutes to balance the body temperature
5. After strenuous exercise ,rest at least 30 minutes before taking the measurement
6. Better repeat the measurement at least twice In order to get the most accurate temperature, and
please remove the probe and wait at least 5 seconds before repeat the measurement, failing to
do may cause inaccuracy
7. Normal body temperature is about 35.5℃～37.8℃, regular temperature measurement help to
know about your healthy temperature .
8. Clean the infrared sensor with a soft cloth moistened with some clinical alcohol in a gentle
manner after every measurement, failing to do may cause inaccuracy
9. Don’t touch or blow infrared sensor, or may cause inaccuracy
10. This product is taken to measure human body temperature by measuring the forehead
temperature
11. During the measurement, move the temperature away immediately after hear a “beep”, or may
Alicn Medical (Shenzhen), Inc.
cause inaccuracy
Connect the Bluetooth:
1. Turn on the thermometer by press the on/off button
2. Turn on the Bluetooth that carried on the mobile terminal, search and connect
3. After measurement, the measurement result transmit to the mobile terminal automatic
Quickly start: this product can booth measure forehead temperature and environmental object
temperature (like milk, water)
1. Select measurement pattern
Push the "mode switch" button to the upper end, enter the Forehead measurement pattern.
Push the "mode switch" button to the lower end, enter the Environmental measurement pattern.
2. Turn on the thermometer by press the on/off button
3. Aim the infrared forehead thermometer at the forehead or the environment object, stay a
distance of 15mm-50mm
4. Press the start button
Alicn Medical (Shenzhen), Inc.
5. Read the temperature showed on the LCD
6. Complete the measurement, turn the thermometer off by press the on/off button
Warning: Pay attention not to press the on/off button and the start button at the same time.
Notice:
Forehead measurement: blue backlight and LCD indicates “Lo” hint that the temperature is lower
than 32.0℃,two short beeps ,blue backlight and LCD indicates “Hi” hint that the temperature is
over than 42.2℃, a long beep and orange backlight hint that the temperature is below 36.0℃，a
long beep and blue backlight hint that the temperature is below 37.8.0℃,six short beeps and red
backlight hint that the temperature is equal to or over 37.8℃
Object measurement: LCD display blue backlight at this measure pattern.
Recall 32 readings in memory mode
This thermometer can recall the last 32 readings.
1. Turn off the unit
2. Press the start button enter the memory mode, and press start button again it will display last
memory 01.(01 is the last memory)
3. Press the start again button to check next memory
Table of contents
