Allen-Bradley 140G-BML User manual

WARNING:
WARNUNG:
AVERTISSEMENT:
To prevent electrical shock, disconnect from power source before
installing or servicing. Install in suitable enclosure. Keep free from contaminants.
(Follow NFPA70E requirements).
AVVERTENZA: Per prevenire infortuni, togliere tensione prima dell'installazione o
manutenzione. Installare in custodia idonea. Tenere lontano da contaminanti.
(Seguire i requisiti NFPA70E).
Vor Installations- oder Servicearbeiten Stromversorgung zur
Vermeidung von elektrischen Unfällen trennen. Die Geräte müssen in einem
passenden Gehäuse eingebaut und gegen Verschmutzung geschützt werden. (Befolgen
Sie die Anforderungen nach NFPA70E).
Avant le montage et la mise en service, couper l'alimentation
secteur pour éviter toute décharge. Prévoir une mise en coffret ou armoire appropriée.
Protéger le produit contre les environnements agressifs. (Vous devez respecter la
norme NFPA70E).
ADVERTENCIA: Desconéctese de la corriente eléctrica, antes de la instalación o
del servicio, a fin de impedir sacudidas eléctricas. Instálelo en una caja apropiada.
Manténgalo libre de contaminantes. (Cumpla con los requisitos NFPA70E).
ATENÇÃO: Para evitar choques, desconectar da corrente elétrica antes de fazer a
instalação ou a manutenção. Instalar em caixa apropriada. Manter livre de
contaminantes. (Cumpra as exigências da norma NFPA70E).
Installation - Installazione - Instalación
Instalação - -
140G-BML; 140G-BNL
Installation instruction for Left Hand Flex Cable Operator for 140G-M, 140G-N
Istruzioni di installazione
Installationsanleitung
Instructions pour l’installation
Instrucciones de instalación
Bul. 140G/140MG
PN-335101
DIR 10001922837 (Version 00)
1/4-20 x .50 in
Self-Tapping Self-Tapping
CLACK
140G-M
1/4-20 x .50 in
140G-N

(2)
1
2
PN-335101
DIR 10001922837 (Version 00)
140G-M / 140G-N
140G-M / 140G-N
2
2
3
4
1
50 - 60 lb-in
(5.6 - 6.8 Nm)
3/8"
15/16"
(24 mm)
100 lb-in
(11.3 Nm)
3
a
a
OK
1

3
(3)
PN-335101
DIR 10001922837 (Version 00)
> 1.0” (25 mm)
U >0V
e
R > 6.0” (150 mm)
140G-M / 140G-N
13.5”
(342.9 mm)
5.0”
(127 mm)
(4) - ø 0.218”
((4) - ø 5.5 mm)
50 - 60 lb-in
(5.6 - 6.8 Nm)
3/8"

(4)
PN-335101
DIR 10001922837 (Version 00)
4a 140G-M 4b 140G-N
3
17 lb-in
(2 Nm)
140G-M
5
7
4
4
#2
#2
22 lb-in
(2.5 Nm)
2
3
1
2
1
6
Supplied with
circuit breaker

(5)
PN-335101
DIR 10001922837 (Version 00)
140G-M1, -P1 or -S1 140G-P2
6a 140G-M 6b 140G-N
5a 140G-M 5b 140G-N
1
7/16"
(11 mm)
25 - 35 lb-in
(2.8 - 4.0 Nm)
30 - 40 lb-in
(3.5 - 4.5 Nm)
1
7/16"
(11 mm)
2
2

PN-335101
DIR 10001922837 (Version 00) (6)
7a 140G-M 7b 140G-N
10 - 15 lb-in
(1.2 - 1.7 Nm)
2
1
8
2
1
#1 #1
10 - 15 lb-in
(1.2 - 1.7 Nm)
50 - 60 lb-in
(5.6 - 6.8 Nm)
3/8"
140G-M / 140G-N

PN-335101
DIR 10001922837 (Version 00) (7)
CLACK
1 - Trip Breaker
2 - Reset Breaker
CLACK
See figure A
Vedi figura A
Siehe Abb. A
Voir figure A
Véase figura A
See figure A
Vedi figura A
Siehe Abb. A
Voir figure A
Véase figura A
See figure B
Vedi figura B
Siehe Abb. B
Voir figure B
Véase figura B
OK!
NO!
OK!
4 - Breaker Off
NO!
OK!
3 - Breaker On
NO!
OK!
CLACK

AB
15/16"
(24 mm)
15/16"
(24 mm)
PN-335101
DIR 10001922837 (Version 00)
Copyright © 2015 Rockwell Automation, Inc. All Rights Reserved. Printed in USA.
Publication 140G-IN138A-MU-P - October 2015
Allen-Bradley, Rockwell Software, and Rockwell Automation are trademarks of Rockwell Automation, Inc.
Trademarks not belonging to Rockwell Automation are property of their respective companies.
Rockwell Automation maintains current product environmental information on its website at http://www.rockwellautomation.com/rockwellautomation/about-us/sustainability-ethics/product-environmental-compliance.page.
RESET OFF
ON
100 lb-in
(11.3 Nm)
100 lb-in
(11.3 Nm)