Allen + Roth 261207 User manual

ITEM # 1083164/1083171
VANITY WITH TOP
ATTACH YOUR RECEIPT HERE
Français p. 8
Español p. 15
allen + roth®is a registered trademark
of LF, LLC. All Rights Reserved.
welcoming • sophisticated • inspiring
1
F
Model # 261207/261065
PH18231
Serial Number Purchase Date
Questions, problems, missing parts? Before returning to your retailer, call our customer
service department at 1-866-439-9800, Mon.-Fri. 8 a.m.- 8 p.m.E ST.

2
PACKAGE CONTENTS
HARDWARE CONTENTS
Touch-Up Pen
Qty:1
aa
迅
捷PDF
编辑器
PART DESCRIPTION QUANTITY
A Vanity 1
B Top (pre assembled
to Vanity (A))
1
CBacksplash 1
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or install this
product.
WARNING
•Keep small parts away from children.
•Installing the item will require more than one person.
CAUTION
•DO NOT try to pry off top from vanity. Damage to top or vanity may occur.
• Use care when assembling the vanity; take your time and follow the assembly instructions
closely.
KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.
A
B
C

3
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and hardware contents list. If any part is missing or damaged, do not attempt to
assemble the product.
Estimated Installation Time: 20-30 minutes (24 hours for adhesive to dry).
Tools Required for Installation (not included): Silicone compound, Utility knife.
INSTALLATION INSTRUCTIONS
Step 1: Vanity Drawer Removal
1
1a. Open the preassembled drawer as far as possible.
1b. Simultaneously press the right side spring clip
downward and left side spring clip upward.
1c. Once both springs clips are held in the indicated
position, pull the drawer straight out.

4
INSTALLATION INSTRUCTIONS
2a. If the doors preassembled to vanity base
(A) require adjustment, follow the below
options as needed:
To adjust door up or down, loosen screws
(a ), adjust door and retighten screws.
To adjust door left and right, turn screw
(b)in or out.
To adjust door in and out, loosen screw
(c), adjust door and retighten screw.
Step 2: Hinge Adjustable For Door Alignment
2
A
Step 3: Adjustable Level.
3
3a. In case of uneven floors, floor levelers are
provided at the bottom of the vanity. If necessary,
adjust floor levelers by hand to correct tilting
and/ or level doors.

5
INSTALLATION INSTRUCTIONS
Step 4: Backsplash Installation
4a. To mount the backslash (C) to the wall,
apply a thin bead of silicone compound
(not included) to the unpolished backside
and bottom of the backsplash(C). Position
backsplash (C) as shown onto vanity top
(A) and against the wall. Clean any ex cess
silicone compound before allowing to dry.
4C
A
24.39 m

6
CARE AND MAINTENANCE
• Dust the vanity regularly with a soft, non-lint producing cloth or household dusting product.
• You can clean the vanity with a gentle, non-abrasive household cleaner.
• Make sure to dry the wood immediately with a soft cloth or towel.
• The stone top can be cleaned using standard marble cleaning agents available at your local
supplier.
• Tips for using touch-up pen (AA): For scratches, stroke in direction of scratch. Rub off excess
colorant promptly with a soft cloth.
IMPORTANT
The vanity top and backsplash are made from stone slabs. Due to its natural stone beauty, every
stone top will have its own unique characteristics such as veining, color variances and natural surface
textures.
• Use caution placing items such as soap or any fragranced material on the stone surface. Use a
soap dish,coaster or similar item to protect the surface if placing any soap of fragranced products on
the stone.
• If soap or fragranced products come in contact with the stone top, rinse the surface with water and
dry using a soft non-abrasive cloth.
• DO NOT use products to clean the stone top that contain acetone, lemon, vinegar or other acids as
these may cause damage to the stone surface.
• This vanity top is pre-sealed at the factory, Periodically reseal is required. As it is porous and
various by nature, more frequent application is recommended and may be required depending on the
usage. Follow sealer manufacturer's recommendation.
• Stone care products are available at your local home center store. Follow the manufacturer's
directions on how to use.
WARRANTY
The manufacturer provides a one year limited warranty for residential use that the vanity combo will
be free from manufacturing defects, provided the original purchaser resides in or owns the home of
installation, and provided the vanity combo is installed and maintained according to the installation
and maintenance instructions contained within and supplied by the manufacturer. The liability will be
limited to cost of products only. This warranty is in lieu of any other express warranties. This warranty
applies only to the original purchaser. This warranty does not apply to any damage on the product by
accident, misuse, or modified, improper installation or by affixing accessories not produced by the
manufacturer. There is no further expressed warranty. The manufacturer shall not be legally
responsible for incidental, consequential or special damages arising at or in connection with product
use or performance except as may otherwise be accorded by law. The manufacturer disclaims any
and all implied warranties.

REPLACEMENT PARTS LIST
PART DESCRIPTION PART #
BVanity Top BV-8157VA-60-001
CBacksplash BV-8157VA-60-002
DDrawer BV-8157VA-60-003
ELeft Door BV-8157VA-60-004
F Right Door BV-8157VA-60-005
aa Touch-Up Pen BV-WH&BE-0001
bb Drawer Pull 4504BA-01
cc Glide Track Set BV-001-CR
dd Slow Colse Hinge BV-002-CR
Printed in China
allen + roth®is a registered trademark of
LF, LLC. All Rights Reserved.
7
For replacement parts, call our customer service department at 1-866-439-9800,
Mon.-Fri.8 a.m.-8 p.m.
EST.

ARTICLE # 1083164/1083171
MEUBLE-LAVABO
AVEC COMPTOIR
JOIGNEZ VOTRE REÇU ICI
allen + roth® est une marque de
commerce déposée de LF, LLC. Tous
droits réservés.
8
F
Modèle # 261207/261065
Numéro de série Date d’achat
Des questions, des problèmes, des pièces manquantes? Avant de retourner l’article au détaillant,
appelez notre service à la clientèle au 1 866 439-9800, entre 9 h et 21 h (HNC), du lundi au vendredi.
7
chaleureux • raffiné • inspirant

9
迅
捷PDF
编辑器
CONTENU DE L’EMBALLAGE
QUINCAILLERIE INCLUSE
Crayon à retouche
Qté : 1
aa
CONSIGNES DE SÉCURITÉ
Assurez-vous de lire et de comprendre l’intégralité de ce manuel avant de tenter d’assembler,
d’installer ou d’utiliser l’article.
AVERTISSEMENT
•Tenez les petites pièces hors de la portée des enfants.
•Demandez l’aide d’une autre personne pour installer l’article.
ATTENTION
•Ne tentez PAS de retirer le comptoir du meuble-lavabo. Vous risqueriez d’endommager
le comptoir ou le meuble-lavabo.
•Soyez prudent lors de l’assemblage du meuble-lavabo; prenez votre temps et suivez
minutieusement les instructions pour l’assemblage.
VEUILLEZ CONSERVER CES INSTRUCTIONS POUR VOUS Y RÉFÉRER ULTÉRIEUREMENT.
PIÈCE DESCRIPTION QUANTIT É
A 1
B Comptoir (préassemblé
au meuble-lavabo [A])
C Dosseret 1
1
A
B
C
Meuble-lavabo

10
1
INSTRUCTIONS POUR L’INSTALLATION
Étape 1 : retrait du tiroir du meuble-lavabo
PRÉPARATION
Avant de commencer l’assemblage de l’article, assurez-vous d’avoir toutes les pièces. Comparez le
contenu de l’emballage avec la liste des pièces et celle de la quincaillerie incluse. S’il y a des pièces
manquantes ou endommagées, ne tentez pas d’assembler l’article.
Temps d’installation approximatif : de 20 à 30 minutes (24 heures pour le séchage de l’adhésif).
Outils nécessaires pour l’installation (non inclus) : composé de silicone et couteau universel.
1c. Une fois que les deux attaches à
ressort sont placées dans la position
indiquée, tirez le tiroir pour le sortir.
1a. Ouvrez le plus possible le tiroir préassemblé.
1b. Pressez simultanément l’attache à ressort
du côté droit en la poussant vers le bas et
l’attache à ressort du côté gauche en la
poussant vers le haut.