Allen Sports AST2 User manual

INSTRUCTIONAL
OWNER’S MANUAL1
MODEL AST2 BIKE TRAILER
Owner’s Manual should be kept for future reference
WARNING
WARNING
WARNING
WARNING
1. Completely read and understand Owner’s Manual before assembling or operating this product.
2. This product should be assembled by an adult
IMPORTANT SAFETY INFORMATION
WARNING #1:
• Failure to follow these warnings and assembly instructions could result in serious injury or death!
• Immediately discard all plastic bags and plastic wrapping materials!
• Maximum weight capacity for this trailer is two (2) children at 100 pounds, max payload!
• Never use this trailer/stroller if it becomes damaged!
• To avoid serious injury, children should always wear the seat belt and the shoulder straps!
• Do not install a car seat or any other seating device not approved by the manufacturer inside the trailer!
• A reflector that complies with CPSC regulations must be visible on the rear of trailer.
• Never leave children unattended in or around this product!
• Never allow children to assemble, fold, or disassemble this unit!
• Accessories or parcels placed in trailer/stroller may cause it to become unstable!
• Not for use with children under 12 months old! Children must be able to support their own heads!
• Before riding, check that all parts are assembled according to the manufacturer instructions!
Also, ensure that the trailer does not interfere with braking, pedaling, or steering of the bicycle!
• Do not allow any of the child’s body, clothing, shoe laces, or toys to come into contact with moving parts!
• Make no modifications to the trailer!
• Tires should be inflated to 25-35 PSI for maximum comfort! Check tire pressure before each use!
• Use a foot pump or hand pump to inflate tires! Pressurized air hoses can cause over inflation!
• Periodically re-check all fasteners to make sure they are tight!
• Clean trailer only with soap and water. Do not use solvents!
TOWING TIPS:
• Make sure your bike brakes work properly! Braking distance is increased when pulling a trailer!
• This trailer is wide! Allow extra clearance near curbs, signs, parked cars, and other obstacles!
• A bicycle with trailer attached requires a wide turning radius! Do not turn sharply!
• Children must wear an approved safety helmet when using this product in trailer mode!
• Never remove protective canopy when pulling children in the trailer!
• Always use the safety flag when pulling this trailer!
• Do not ride over curbs! Avoid bumps and holes! Always signal your turns!
• Use extra caution when turning on uneven pavement, and going downhill!
• Not for use at high speeds! Do not exceed 10 MPH!
• NEVER use this trailer at night!
• Install a rearview mirror on your bike to check on children in trailer!
• Dress children appropriately to prevent them from getting chilled or overheated while riding!
Protect against wind-chill in cold temperatures, and provide adequate ventilation and hydration during
warmer temperatures.
SAFETY TOWING TIPS
INSTRUCTIONAL OWNER’S MANUAL
PRODUCT REGISTRATION:
MAKE SURE TO REGISTER YOUR PURCHASE AT
http://allensportsusa.com/about/product-registration
TO QUALIFY FOR PRODUCT WARRANTY AND TO RECEIVE
IMPORTANT PRODUCT NOTIFICATIONS 1

INSTRUCTIONAL
OWNER’S MANUAL2
FULLY ASSEMBLED TRAILER
QUANTITY DESCRIPTION
1 Frame w/ Canopy, Sling
Seat with 5 point safety
harness, tow bar, tow
bar coupler and rear
wheel bracket attached
2 16” Rear wheels
1 Safety flag
PARTS LIST

INSTRUCTIONAL
OWNER’S MANUAL3
TRAILER ASSEMBLY & OPERATING INSTRUCTIONS
STEP 1:
STEP 2:
STEP 3:
WARNING!: IMMEDIATELY DISCARD ALL PLASTIC BAGS AND WHEEL WRAPPING MATERIALS!
WARNING!: The spring-release pins must be engaged for safe operation of the trailer. Failure to Assemble
properly may result in injury. If the spring-release pins do not engage properly, DO NOT USE.
Call the customer service number as indicated in the attached literature for assembly assistance.
Remove the trailer from the box and check contents against the parts list.
NOTE(S): 1. Lay the trailer on the ground with the black fabric side down.
2. Do not remove the white foam from the wheel axles until STEP 4
OPEN FRAME
Remove trailer and all components from carton. Unfold trailer by pulling the frame and remove all components from
inside (Fig. 2).
A. Lift both side panels into an upright position (Fig 2b).
B. Insert QR Snap Pins through hole in frame and close the snap pin so the loop of the pin is over the pin shaft.
RELEASE THE TOW BAR
1. Turn the trailer on its side so the hitch arm is along the top edge [Fig. 3].
2. Find the quick-release pin that holds the tow bar in place in the tow bar bracket [Fig. 3a]
3. Open the loop of the quick-release pin and remove the pin.
4. Rotate the hitch arm forward until it is seated in the U-channel [Fig. 3b]. Re-install pin in front
holes in the U-channel and close the snap pin so the loop of the pin lock is over the pin shaft.
FIGURE 2.
FIGURE 3.
FIGURE 1.
FIGURE 3A.
FIGURE 1A.
FIGURE 3B.
FIGURE 2B.

INSTRUCTIONAL
OWNER’S MANUAL4
WHEEL INSTALLATION
ATTACHING THE FOUR SEASON COVER
WARNING! Remove the foam from the wheel axles and discard immediately. Do not remove washers.
WARNING!: Check wheels periodically during and before each use to be sure that they have not
become loose. Failure to do so could result in SERIOUS INJURY to you or trailer’s occupants.
WARNING!: Never use the trailer without the four season cover. The front window or bug screen must be
attached to protect children from flying objects.
STEP 1:
STEP 2:
STEP 2:
STEP 3:
STEP 3:
STEP 4:
STEP 4:
STEP 5:
STEP 1:
Lift the trailer back so the right side is up, and locate the right wheel.
Install the wheel axle by sliding the axle completely through the bracket
in the frame as shown.
Wrap the Velcro backed fixing straps and secure the cover around the frame.
Position the four-season cover over the trailer where roll-up window is facing towards the front side of the trailer. (Fig.12).
Insert the Quick Release Pin (tethered to the trailer frame near the wheel bracket)
through the hole in the axle and lock the clip to secure the pin.
Secure the Velcro material at the bottom front of the cover to the matching Velcro material on
the lower front fabric panel.
Repeat for the left wheel. When complete, give each of the wheels a tug to be sure
that they are secure.
NOTE: Wheels must be properly installed with quick release pins closed and
snapped shut. If QR pins are not correctly attached, wheels may fall off.
Do not use if QR pins are missing, or if the closure is damaged or missing.
Connect the slide release buckles affixed to the rear corners of the cover to the matching buckles sewn
the rear side of the trailer cabin (Fig 13).
Connect the elastic cords on the rear cover to the D-Rings which are located on the bottom cabin corners
FIGURE 12. FIGURE 13.
NOTE: The four-season cover is designed to keep passengers and cargo dry and warm in inclement weather. It also protects
the passengers from flying debris. The four-season cover can be rolled up to allow for added ventilation in hot weather.
Velcro closures keep the four-season cover in place when rolled up.

INSTRUCTIONAL
OWNER’S MANUAL5
SAFETY FLAG INSTALLATION
STEP 1: Assemble the flag and insert the end into the small sleeve on the side of the trailer
skin. Reattach the Velcro to secure the cover.
NOTE: Flag should be removed before attempting to fold trailer
WARNING!: This flag is meant for use only with the trailer. This flag is not a toy. Do not let your child play
with this flag at any time. Failure to comply with this warning could result in serious injury
of your child.
WARNING!: Your trailer is designed to attach to most full-sized bicycles. The trailer’s hitch must be
attached to the rear axle of the bike. Do not use trailer if the hitch can not be securely
attached to rear axle. It is recommended that the bicycle(s) to which the trailer will be
attached undergo a safety check by a qualified bicycle mechanic before attaching trailer.
This trailer should never be used with electric bicycles, or any motorcycle or any motorized vehicle
ATTACHING TRAILER TO BICYCLE
STEP 2:
STEP 3:
STEP 4:
STEP 1:
Position hitch over left rear axle of bicycle frame (Fig15).
Loosen LEFT side rear axle to allow the trailer’s hitch to attach to frame.
Tighten axle nut securely, testing to see that hitch is unable to pull loose (Fig16).
Loop Safety Strap around frame and secure to D-ring on hitch arm (Fig 17).
WARNING!: Safety strap must attach to the bike frame when using this product in trailer mode.
FIGURE 15.
FIGURE 16. FIGURE 17.

INSTRUCTIONAL
OWNER’S MANUAL6
SECURING CHILD WITH 5POINT SAFETY HARNESS
WARNING! To avoid serious injury, children should always wear the seat belt, shoulder strap, and a helmet!
STEP 1:
STEP 1:
STEP 2:
NOTE:
NOTE:
STEP 2:
Undo the lap belt buckle and seat the child in the CENTER of the trailer.
Buckle the lap belt [A] over the child’s lap, and pull the strap until the belt is tight.
Undo the lap belt buckle and seat the children in the Left & Right seats of the
trailer. Buckle the lap belt [A] over each child’s lap, and pull the strap until
the belt is tight.
FOR ONE CHILD: ONE CHILD:
TWO CHILDREN:
FOR TWO CHILDREN:
Place the two center shoulder straps [C] over the child’s shoulders, and
clip both straps into “D” Ring [D] of the center crotch strap. Adjust shoul-
der strap height of the child, then pull the straps until they are snug.
Clip the outer shoulder strap on either side into the “D” Ring of the outer
crotch strap directly below. This will keep the straps that are not in use out of
the way.
Place the two center shoulder straps [B] over each child’s shoulders, and clip
both straps into “D” Ring [C] of the center crotch strap. Adjust shoulder strap
height of the straps until they are snug - you should be able to fit two average
adult fingers between the belt and the child.
The buckle should be centered in your child’s abdomen. Hook the shoulder
straps to the D-rings on the buckle and adjust the ladder locks so they fit snugly.
WARNING!: Adjust the straps so that the crotch strap and shoulder straps meet at the child’s stomach level,
NOT at the chest level!
STEP 2:
STEP 3:
STEP 4:
STEP 1:
Remove QR Snap from hitch connection
Remove Safety strap by releasing D-Ring
Pull trailer arm away from black hitch
Black Hitch attached to axle can remain on the bicycle for easy reattachment of the trailer.
REMOVAL OF TRAILER
TRAILER MAINTENANCE
Your trailer will give you many years of service with minimal care. To ensure safe and dependable operation, we recommend
the following regular maintenance. Before each ride:
STEP 2:
STEP 3:
STEP 4:
STEP 5:
STEP 1:
Make sure that wheels are fully secure on the frame. Wheels must be fully inserted to lock in place.
Check all fasteners to make sure that they are tight, and tighten or replace as needed.
Check tires for wear and proper inflation as listed on the tire sidewall. Use only hand-operated pump to avoid tire damage.
Under- or over inflation can result in unsafe handling.
Double check hitch attachment, making sure that QR Pin is locked, and that safety strap is in place.
Check harness strap for wear, and made sure that buckles lock properly.
ANNUALLY: Once a year, or sooner if needed, have the trailer inspected by a qualified bicycle mechanic for signs of wear or needed adjustment.
AS NEEDED: Trailer can be cleaned with a mild detergent and water. Do not remove seat or cover for washing. Do not use harsh chemicals or water,
as they may damage fabrics or the frame materials or surfaces.

INSTRUCTIONAL
OWNER’S MANUAL7
FOLDING FOR STORAGE AND TRANSPORT
STEP 2:
STEP 3:
STEP 4:
STEP 5:
STEP 6:
STEP 7:
STEP 8:
STEP 9:
STEP 1:
Unclip the tow bar safety strap from the “D” ring, and remove pin to remove hitch
from frame.
Remove children and all cargo from inside the passenger compartment.
Clip the end of the strap back on to the tow bar “D” ring.
Remove the flag and pole and separate the three sections.
Remove the quick-release pins form the stub axles of the rear wheels.
Remove the quick-release pin from the tow bar bracket at the front corner of the trailer.
Fold the tow bar back under the trailer, and replace the quick-release pin through
the tow bar and U-channel
Place wheels and flag inside the passenger compartment, and close the front cover.
Fold upper cabin as shown above:
a. Remove 4-season Rain cover
b. Remove QR pin from both sides.
c. Fold frame down as shown.
d. Fold in until trailer is flat
NOTE: Store trailer in a cool, dry environment, away from direct sunlight. After extended periods of storage, check tires for
wear or cracking, and fabric and strapping for signs of wear.
After extended periods of storage, it is recommended that the trailer is inspected by a qualified bicycle mechanic
prior to use.
R. A. ALLEN CO., INC. 60 THOREAU ST. 161 CONCORD, MA 01742
Product designed in USA, Made in Ningbo, China
WARRANTY
IF YOUR PRODUCT REQUIRES WARRANTY SERVICE, PLEASE DO NOT RETURN IT TO RETAIL STORE.
PLEASE CONTACT:
ALLEN SPORTS USA
[email protected]
Please note that all returns and exchanges are subject to the return policy of the retailer where
the product was originally purchased
@AllenSportsUSA@AllenSportsUSA/AllenSportsUSA
Get the lastest news, info, give-a-ways
and pics on our social media sites!