Allied Telesis Converteon AT-CV5M01 User manual

Allied Telesis www.alliedtelesis.com
Datasheet | Media Converters
AT-CV5M01
Converteon™ Series Management Card
Overview
The AT-CV5M01 adds management
configuration and monitoring capabilities to the
Converteon™ range of media chassis. A chassis
can be installed with any range of media blades,
which can be used in an unmanaged mode.
With the addition of a management card to the
chassis, all the blades setup option can be
configured via the management module,
allowing a network administrator to change
configuration remotely, and monitor the status
of both the chassis and the links.
Management Modes
The AT-CV5M01 supports three management
modes
•SNMP
•Telnet
•Local RS232
Both the local RS232 and the Telnet mode
allow the user to monitor and manage a
Converteon™ chassis using a menu driven,
command line inferface (CLI). When configured
for SNMP, a network administrator can not only
configure the chassis, but also receive network
warnings relative to link failures, power supply
failures and equipment being over temperature,
etc.
Connection byan RS232 port is achieved by
attaching a computer or terminal to the DB-9
connector on the front panel of the
management card.Telnet and SNMP sessions
connect via the 10/100TX connection also
located on the front panel.
In addition, each management card has six
diagnostic LEDs to aid in troubleshooting.
IEEE 802.3ah (OAM) Remote
Management
When deployed with any media blades that
support IEEE 802.3ah ‘Ethernet in the First Mile’
such as the AT-CM202, AT-CM2K0S, and
AT-CM70S modules, the AT-CV5M01
management card can also manage and monitor
the remote blades connected only to the local
chassis over fiber optics.
Hassle Free Support
All Allied Telesis Ethernet media converter line
cards havefree technical support, ensuring
trouble-free installation.
Key Features
•Provides Management support to
Converteon™ chassis
•SNMP, Telnet and Local RS232 support
•SNMP v1, v2c, and v3
•Event Logging
•Syslog support
•DHCP support
•IEEE 802.3ah Remote blade management

USA Headquarters |19800 North Creek Parkway |Suite 200 |Bothell |WA 98011 |USA |T: [phone] |F: [phone]
European Headquarters |Via Motta 24 |6830 Chiasso |Switzerland |T: +41 91 69769.00 |F: +41 91 69769.11
Asia-Pacific Headquarters |11 Tai Seng Link |Singapore |534182 |T: [phone] |F: [phone]
www.alliedtelesis.com
©2007 AlliedTelesis Inc. All rights reserved. Information in this document is subject to change without notice. All company names, logos, and product designs that are trademarks or registered trademarks are the property of their respective owners. 617-000125 Rev. E
AT-CV5M01 |Converteon™ Series Management Card
Technical Specifications
Status Indicators
LED State Description
PWR Green The CPM card is receiving power
OFF The CPM card is not receiving power
RDY Green The CPM card has passed diagnostics
and is ready
OFF The CPM card has failed diagnostics
and is not ready
FLT Red The CPM card has experienced fault
condition
OFF The CPM card has reported no fault
condition
LK Green Link established on the card Ethernet
port
OFF No link established on the card
Ethernet port
AT Flashing TX/RX activity established on the
card Ethernet port
OFF No activity established on the card
Ethernet port
FD Green The CPM card is operating in
full-duplex mode
OFF The CPM card is operating in
half-duplex mode
Connectors
RS232 Female DB-9
Baud Speed 1200 ~ 115200bps
Ethernet 10/100TX, Auto MDI/MD-IX
Management Features
Management Interfaces
RS232 (Local Login): Username and Password
protected (Enable/Disable Local
Login)
Telnet (Remote Login): Username and Password
protected (Enable/Disable Remote
Login)
SNMP Managers: Named SNMP Manager
(Enable/Disable SNMP)
(Up to 4 SNMP manager)
DHCP
DHCP Client (Enable/Disable)
System Warnings
Over Temperature warning
PSU failure warning
Fan failure warnings
Blade failure
Insert/Remove Power Supply
Insert/Remove Fan module
Insert/Remove blade
Operational Warnings
Link Up/Down
Event Logging
Time and Date stamp for all log entries
Internal Log
Syslog
Administration
Diagnostics
Firmware Upgrade (Mangement card)
Firmware Upgrade (Blade firmware)
Configure MissingLinkTM
Configure Smart MissingLinkTM
Configure Link Monitor
Configure IEEE 802.3ah OAM
Physical Specifications
Dimensions 2.2cm x 7.3cm x 13cm
(H x W x L) (.855” x 2.89” x 5.10”)
Weight: 0.60 lbs
0.27 kg
Package Contents
One AT-CV5M01 CPM Card
One DB-9 RS-232 Serial Cable
Installation Guide
Warranty Card
Power Characteristics
Input Supply Voltage 5vDC, 3.3vDC
Maximum Input Current 1.15 A(5vDC), 0.86 A (3.3vDC)
Power Consumption 9.6 watts maximum
Environmental Specifications
Operating Temperature 0°C to 40°C
(32°F to 104°F)
Storage Temperature -25°C to 70°C
(-13°Fto 158°F)
Operating Relative Humidity5% to 90% RH
(non-condensing)
Storage Relative Humidity 5% to 95% RH
(non-condensing)
Operating Altitude Range Up to 3,048m (10,000ft)
Standards
EMI part 15:
FCC class A, EN55022 class A, VCCI class A, C-Tick, CE
Immunity:
EN55024
Safety:
UL60950-1 (cULUS), EN60950-1 (TUV)
Quality and Reliability:
MTBF> 100,000 hrs
Electrical Interfaces:
UL60950 (UL/cULus)
EN60950 (TUV)
CSA22.2 No. 950
Ordering Information
AT-CV5M01
SNMP Management Module
Associated Products
AT-CV1000-xx
Single slot Converteon™ chassis
AT-CV1203-xx
Two slot Converteon™ chassis
AT-CV5000-xx
18 slot, Converteon™ chassis