Alpha SMILE5 User instructions

SMILE5 2xCascading
Wiring and Setting Procedure
V01

___________________________________________________________________
Alpha ESS Co., Ltd. Page I of 5
Your Smart Energy
Version Information
Version
Date
Content
V01
Jun. 3, 2018
New

___________________________________________________________________
Alpha ESS Co., Ltd. Page 2 of 5
Your Smart Energy
Content
Version Information .......................................................................................... I
Content.............................................................................................................. 2
Wiring............................................................................................................ 3
Setting........................................................................................................... 4

___________________________________________________________________
Alpha ESS Co., Ltd. Page 3 of 5
Your Smart Energy
Wiring
Please refer to the following diagram to connect power cables and the meter
communication cable.
The local communication cables connecting L1 SMILE5 and L2 SMILE5 is regular
network cables (568B)
NOTE:
1. The EMS firmware version V1.01.97 and its higher versions have this cascading
function. The corresponding DSPfirmware version is V1.43 and its higher versions.
2. Backup Box cannot be used if you use the function of cascading.
3. The SMILE5 connected with L1 is the mater device, the other connected with L2
is the slave device.
4. The LAN1 port of both devices should be connected with the internet.
5. When using the function of cascading, the device does not have the idle mode.

___________________________________________________________________
Alpha ESS Co., Ltd. Page 4 of 5
Your Smart Energy
Setting
Step 1: Please enter LCD main interface
Step 2: Please press Enter to enter the
Menu
Step 3: Press Enter to enter Password
menu and then enter the password 1111
Step 4: Please go to the Setting menu,
choose Function and press enter
Step 5: Please go to the function menu,
choose “Parallel” and press enter
Step 6: Please go to the parallel menu,
choose “Select” as “Yes” and press enter
Step 7: Please choose “Phase” as L1
(master) and press enter
Step 8: Please choose “Mode” as
“Parallel mode” and press enter.
Step 9: please repeat Step 1 to 8 to set the other device as L2 (slave)