Alpkit JARAN User manual

If this product does not meet your expectations upon
delivery or does not live up to the demands placed upon
it, please return it within 3 years of purchase for repair,
replacement or refund. If the problem is our fault then
we will do this to your satisfaction, if it’s your fault we will
help the best we can!
Email: [email protected]
Phone: [phone]
Website: alpkit.com/support
IMPORTANT:
Thank you for purchasing the Alpkit Jaran. Please curtail
your excitement and do not use this product until you have
read, understood, and complied with all the instructions and
warnings contained within this manual.
Introducing your new Jaran tent. A
spacious 3 season tent with decent
sized vestibules for your stuf;
designed to strike the right balance
between weight, durability, and
space.
JARAN
PITCHING INSTRUCTIONS
1.
2.
3. Assemble all of the poles and lay them over the inner [Fig 1]
the shorter pole lying between the two doors, hubs facing
down.
Insert the ends of each pole into the sockets located at the
corners of the inner [Fig 2]
4.
WARNING
This tent is NOT fireproof and will burn in seconds if
Do not cook in your tent.
Do not place hot appliances close to the walls or roof of your
tent, observe safety warnings for any appliances and do not
allow children to play near them.
Keep exits of tent free from obstructions and woodland
creatures, they will steal your food.
Maintain adequate ventilation at all times, death by
suffocation is possible. Always store any cheesy socks in
vestibules or outside tent.
Anchor your tent carefully at all times: the use of tent pegs
is recommended, anchors are very heavy.
Choose your campsite wisely, be aware of the possibility of
and airborne whales.
Go Nice Places, Do Good Things.
Using an additional footprint provides extra protextion if
pitching on rough or boggy ground,
falling rocks and trees, lightning, flash floods, avalanches
exposed to flame or excessive heat.
Jaran pitches inner first with a minimum of 6 pegs.
Ensure the ground is free from sharp objects and rocks
that could damage the groundsheet. Lay out the groundsheet
and peg out the corners.
(1)
(2)

HAPPY CAMPING!
5. Your poles are now ready to suspend the inner tent [Fig. 3] 6. Locate the plastic clips of the inner canopy [Fig. 4] and connect
to the poles, connect the two circular plastic attachments
clip to the downward facing hubs.
Throw the flysheet over the inner, using the colour-coded tabs
to match the inner and the flysheet.
(3)
CARE AND MAINTENANCE
Clean and dry tent thoroughly after each use.
Never use a washing machine or tumble dryer to clean your
tent. Car washes are also frowned upon.
Spot clean with mild detergent and warm water.
Air dry only.
Pack tent carefully to avoid punctures.
Avoid prolonged UV exposure.
SPECIFICATION
Sleeps: Jaran 2: 2, Jaran 3: 3
Outer: 40d Nylon, PU both sides, ripstop
(HH: 2,000mm)
Inner mesh: 20d Nylon Breathable ripstop
Floor: 40d Nylon, PU both sides, ripstop (HH: 3,000mm)
Poles: 7001-T6 alloy
Pegs: 10 pegs, Alpkit Candy Canes
CONTINUE THE JOURNEY
When your partnership with this product is over please don’t
leave it hidden in a cupboard, never to see another adventure.
Wash it, pass it on, give to a friend, sell it, donate it to charity,
make it into something else or recycle it and let someone else
live their dream.
FIELD REPAIRS
If you are unlucky enough to rip your tent, duct tape or
StormSure tough tape will do the trick for field repairs.
When you are home and dry, you can repair your tent
properly. Using the Spares kit you can patch up your tent
with more fabric. Remember to seal any seams!
If a pole breaks, use a pole splint or sleeve as a temporary
repair.
If you need any help of spare parts then please get in touch
and we will find a fix for your tent.
In store service for your kit: alpkit.com/stores
For more ideas on how you can extend the life of or donate
your outdoor products visit: alpkit.com/continuum
HACK, PATCH & SEW
7.
(4)
(5)
Fasten the toggles to the sockets above each door [Fig. 5] and
the velcro tabs around the poles, hook the plastic corner tabs.
Tension the tent by adjusting the buckles at the pegout points,
peg and tension the guylines as required.
8.
9.