Alu-Cab SH-BKT-KH User manual

Shower Cube
to
Khaya & Canopy Camper XC
(SH-BKT-KH)

2
1. Shower Cubicle Fitment – Tools, Fasteners & Materials
The tables below show the equipment, i.e. tools and fasteners required to start the
shower cubicle fitment onto a Khaya & XC Canopy Camper.
1.1. Tools & Items Required:
ITEM
Turpentine
Cloth
Black sealant, silicone or Sikaflex
1.1. Fasteners supplied: (Included with Shower Cube brackets)
ITEM
QTY
HEX HEAD BOLT M8X20
2
HEX HEAD BOLT M8X25
4
M8 FLAT WASHER
12
M8 NYLOC NUT
12
M8 PLASTIC NUT CAP
12
1.2. Hardware Required: (Included with Shower Cube)
ITEM
DESCRIPTION
QTY
SHOWER CUBICLE
SHOWER CUBICLE ASSEMBLY
1
SHOWER CUBICLE BAG
BLACK SHOWER CUBICLE BAG
1
SHOWER CURTAIN
GREY SHOWER CURTAIN
1
KHAYA MOUNTING BRACKET
415-SHW-MNT-BKT-03-05
1
AWNING BRACKET
LR-AW-000-002
1
AWNING BRACKET BACK PLATE
AWN-BKT-02-002
1
TOOLS
Ratchet
13mm Socket
13mm Ring Flat Spanner
Drill
Drill Bit Ø8.5

3
x1
x1
x1
Figure 1.SHOWER CUBICLE
Figure 2. LR-AW-000-002
Figure 3. 415-SHW-MNT-BKT-03-05
Figure4. AWN-BKT-02-002

4
2. Mounting the brackets to the Khaya & Landcruiser XC Canopy
Camper
Align the top edge of the bracket with the top edge of the tent base, with the tab of
the shower mount bracket(415-SHW-MNT-BKT-03-05) up against the tent base as seen
below in Fig 5 & 6
Figure 5.
Figure 6.
Tab flush up
against the
tent base
Align the top edges
use holes as jig to
drill holes into
the body. And
use

5
2. Remember to use Sika flex between the brackets and end plates for
sealing purposes.
Fit the bracket (LR-AW-000-002) 740mm from the front of the tent base as seen below
in Fig 8.
M8 Nyloc nuts and washers
AWN-BKT-02-002
M8x20mm
Hex head
bolt and M8
washers
415-SHW-MNT-BKT-03-05
740mm
Figure 8.
Figure 7.

6
Remember to apply Sika flex between the brackets and the tent
base for sealing purposes.
LR-AW-000-002
M8 nyloc
nuts and M8
washers
Fig 9.
Use existing holes on the bracket as a jig for drilling holes
M8x25mm
Hex head
bolt and M8
washer

7
3. Mounting the shower cube.
Place shower cubicle assembly with the bag on mounting brackets and secure shower
cubicle to the mounting brackets using the same nuts that where removed in fig 10.
And place M8 nut caps on all nuts.
Fig 10.
Loosen these 4 M8 nuts before
fitting to mounting brackets on the
tent .
Figure 11.
Figure 12.