Amantii TRU-VIEW-XL User manual

Fix your Fireplace
TRU-VIEW-XL

Content
•How to replace LED light
•How to replace flicker motor
•How to replace heating element
•How to replace the PCB board
•How to replace the signal receiver
•How to replace the top light

Replace LED light
Unscrew the knobs on both sides of the unit and then remove
the glass.
Step 1
Knob on
each side
Replace emberbed LED light

After two knobs are removed, the
front glass be released and come away
from the unit. Take care to catchit.
Front glass

Step 2
Unscrew twoscrews on both sides and then
totake off two barsand the ember bed glass
panel
Zoomed view

After the knobs and fending bars are removed,
you can remove the ember bed glass panel and
long steel bar with it.

Step 3
After the ember bed glass panel is removed, youcan now replace
the LED lightfor ember bed effect.(Replace flame light see STEP 4)

Step 4
Zoomed view
Zoomed view
Unscrew 2 screws on the left side
and 2 screws on the right side of
the fireplace (where the arrows
marked) to take off the fending
bars. After the bars are removed,
you can remove two side glass
panels.

Screws and fending bars Side glass panels
Afterscrews and fending bars are removed,
now you can remove the side glass panels.

Zoomed view
The top light located here
Unscrew 3 screws located in the canopy of the
unit then disconnect cable toremove the top
light from the fireplace.
Step 5