Amart Furniture GENEVIEVE 70157 User manual

Imported by Amart Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please phone
Amart Furniture, Customer Service Free call 1800 351 084
ASSEMBLY INSTRUCTION
GENEVIEVE DINING TABLE
ITEM CODE 70157
Imported by Amart Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please phone
Amart Furniture, Customer Service Free call 1800 351 084
170157

PRE-ASSEMBLY PREPARATION
Before you start:
1. Choose a clean, level, spacious assembly area. Avoid hard surfaces that may damage
the product
2. Take care when lifting. Product should be assembled as near as possible to the point
of use
3. Ensure that you have all required contents for complete assembly
4. Always read the assembly instructions carefully before beginning assembly.
5. Keep all hardware parts and packaging out of reach of small children.
6. Do not over tighten the screws and bolts as this may damage the threads
270157

PARTS LIST
370157

STEP 1: Fasten metal bracket (f) to table legs ② with hex bolts
(b) and flat washers (c). Do not fully tighten the hex bolts, make
sure the legs are level and even before fully tightening. Place
wood block(d) into the metal bracket(f). Remove the yellow film
backing from the silicone stickers (e) and stick to the stainless
steel plates.
STEP 2: Peel the white film backing from the silicone stickers(e)
and with 2 people, place the glass table top① on top of the
legs②.
470157
Note: The glass is marked for
easy alignment with the
silicone stickers. These can be
easily wiped away after the
table is assembled.

STEP 3: Use glass cleaner to remove the silicone guide marks
and any fingerprints from assembly.
Assembly is complete.
570157

670157
CARE AND MAINTENANCE
Glass
If the glass is chipped or broken, stop using the product and consult place of purchase
WARNING:
• Do not place very hot or cold items on the glass surface unless adequately thick table mats
are used to prevent such items coming in
contact with the glass
• Do not sit or stand upon the glass surface
• Do not use the glass as a chopping surface
• Do not strike the glass with hard or pointed items
• When cleaning the glass panels use a damp cloth or leather with washing up liquid or soft
soap if necessary. Do not use washing
powders or any other substances containing abrasives since these may scratch the glass
Timber
As our timber is supplied from sustainable forests there will be natural variations in surface
texture and grain like knots, mineral streaks
and sap runs that may affect the finish. These differences in character are not defects, but
distinctions that make each piece of
furniture unique
Our furniture is built to last. Following these steps for basic care should protect your
investment for years to come
•Dust frequently with a clean damp lint-free cloth. This will help remove abrasive build up
which can damage a finish over time
•Do not place hot objects on any furniture surface. Always use a hot plate or placemat.
Laminate and lacquer finishes on table tops
•provide added scratch and heat resistance to our furniture, but they can still be damaged
without proper care
•Avoid exposing your furniture to strong sunlight, heat outlet, open windows or dampness.
Prolonged exposure to direct sunlight can
•fade the finish of your furniture, while extreme temperature and humidity changes can
cause cracking or splitting
•Do not expose your furniture to any liquids. Never allow water to sit on your furniture.
Alcohol, nail polish and perfume are also
•dangerous as they will dissolve the lacquer finish on contact and may require professional
repairs
•Do not allow plastic to come in direct contact with your furniture. Chemicals in the plastic
of placemats etc. may soften and mark the finish if left in contact with the furniture for a
period of time