Amart Furniture ZAMI 65498 User manual

INSERT LINE DRAWING IMAGE OF
PRODUCT INCLUDING DIMENSIONS
HEIGHT –WIDTH - DEPTH
Imported by Amart Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please phone
Amart Furniture, Customer Service Free call 1800 351 084
ASSEMBLY INSTRUCTION
ZAMI DESK
ITEM CODE 65498
Imported by Amart Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please phone
Amart Furniture, Customer Service Free call 1800 351 084
1 65498

PRE-ASSEMBLY PREPARATION
Before you start:
1. Choose a clean, level, spacious assembly area. Avoid hard surfaces that may
damage the product
2. Take care when lifting. Product should be assembled as near as possible to
the point of use
3. Ensure that you have all required contents for complete assembly
4. Always read the assembly instructions carefully before beginning assembly.
5. Keep all hardware parts and packaging out of reach of small children.
6. Do not over tighten the screws and bolts as this may damage the threads
2 65498
10 Minutes 2 PEOPLE REQUIRED FOR THE
ASSEMBLY
x
ADD OR REMOVE
TOOLS REQUIRED
2

PARTS LIST
1 Top panel
2 Square Tube
3 Frame
4 Cross Bar
5
6
7
8
EXPLODED VIEW
INSERT EXPLODED
EXAMPLE OF PRODUCT.
INCLUDING PART
NUMBERS
3 65498
A B
M6x30mm
8pcs
M4x12mm
5pcs
C
M4mm
1pcs
D
1pcs

STEP
1:
As shown in the following figure, connect frame (3) with
Square Tube (2), using Bolt (A) and tighten with Allen Key (D)
STEP
2: C
onnect Cross Bar (4) with Bolt (B) and Nut (C), no tightening;
Use Bolt
(B) to lock the Cross Bar into the corresponding screw hole of
frame (3);
Lock and tighten all the screws.
4 65498

STEP
3:Embedding the desktop panel as shown on the
assembled surface of the rack, fix and lock tightly the
corresponding screw hole with Bolt (A).
ASSEMBLY
IS COMPLETE
5 65498

1. Attach one Mounting Plate to the wall with the Large Screws.
Make sure to attach the Mounting Plate into a stud. If mounting
into brick or masonry you will need to acquire wall anchors.
2. Attach the second Mounting Plate to the furniture frame with the
Short Screws.
3. Move the furniture to its final position. Thread a Wall Strap
through the both Mounting Plates and tighten until snug. Do not
over tighten.
4. Make sure that the Mounting Plates are firmly attached to the
wall and furniture and that the Wall Strap is snug.
SAFETY BRACKETS INSTRUCTIONS
6 65498

GENERAL PRODUCT CARE
To protect your furniture, we suggest the following:
*Avoid placing your furniture in direct sunlight.
*Do not place furniture directly under windows.
*Do not place sharp materials (knife, fork, etc.) directly
onto your furniture as sharp material may scrape and
damage the finish.
*Do not place material with high temperature directly onto
the surface of your furniture.
*Clean up spills quickly. Water left over a prolonged period
of time may cause damage. Alcohol, perfume, nail polishes,
aftershave and some medication may cause severe finish
damage if not cleaned immediately.
*Use a clean, soft, dry, lint free absorbent cloth to clean
your furniture. Do not use any detergent as they may
contain ingredients that may react and damage the finish.
NOTE: If the above care advise is not adhered to your
product warranty may become void
7 65498