
reproduced
from American Control Electronics® technical data in this document are
American Control Electronics®makes
American Control Electronics®assumes no
responsibility for any errors that may appear in this document and makes no commitment to
2. handheld tachometer may be used to measure motor speed.
4. the s
4.
2.
2. to go from minimum speed to maximum speed.
3.
3.
2. to go from maximum speed to minimum speed.
3.
3.
torque limit and then;
1. motor leads.
2. rated speed.
4.
Calibration
100%
150%
200%
230 V
yourself.
MOTOR CONNECTIONS
V
internal to the motor
yourself.
V
V
Operation
synchronous.
to convert a single phase 115 VAC input into a three phase 230 VAC output, it is recommended to use
MOTOR TYPES
LEDs
LED
Torque Limit
LED
LED
Enable
LED
STARTUP
Startup
either 115VAC or 230VAC to match the AC line source.
either 115VAC or 230VAC to match the AC line
source.
mA analog signal.
in column 2 if using a 0-10 VDC analog signal.
analog signal.
braking to brake the motor to zero speed.
2. Apply AC line voltage.
SELECT SWITCHES
Braking