American DJ Ruby Star User manual

User Instructions
©
American DJ
®
- www.americandj.com - Ruby Star™ Instruction Manual Page 2
Unpacking:
Thank you for purchasing the Ruby Star™ by American
DJ
®
.
Every Ruby Star™ has been thoroughly tested and has been
shipped in perfect operating condition. Carefully check the shipping
carton for damage that may have occurred during shipping. If the
carton appears to be damaged, carefully inspect your unit for any
damage and be sure all equipment necessary to operate the unit has
arrived intact. In the event damage has been found or parts are miss-
ing, please contact our toll free customer support number for further
instructions. Please do not return the unit to your dealer without  rst
contacting customer support.
Introduction:
The Ruby Star™ is a unique red laser effect that cre-
ates several different patterns. The unit uses six mirror to bounce the
laser re ection over a wide area. This unit has a sound-active mode
that allows the unit to re ect on all six mirrors. The unit’s sound sen-
sitivity may be adjusted by a sensitivity adjustment on the rear of the
unit. When the sensitivity is turned completely down the unit can be
used to project the laser patterns to a single location.
Customer Support:
American DJ
®
provides a toll free customer
support line, to provide set up help and to answer any question should
you encounter problems during your set up or initial operation. You
may also visit us on the web at www.americandj.com for any com-
ments or suggestions.
For service related issue please contact Ameri-
can DJ
®
.
Service Hours are Monday through Friday 9:00 a.m. to 5:00
p.m. Paci c Standard Time.
Voice:
[phone]
Fax:
[phone]
E-mail:
[email protected]
Warning!
To prevent or reduce the risk of electrical shock or  re, do
not expose this unit to rain or moisture.
Caution!
There are no user serviceable parts inside this unit. Do not
attempt any repairs yourself, doing so will void your manufactures
warranty. In the unlikely event your unit may require service please
contact American DJ customer support.
Please do not discard the shipping carton in the trash. Please recycle
when ever possible.
American DJ
®
American DJ®American DJ
4295 Charter Street
Los Angeles, CA. 90058
www.americandj.com
Rev. 03/02
Ruby Star™ General Introduction

©
American DJ
®
- www.americandj.com - Ruby Star™ Instruction Manual Page 4
©
American DJ
®
- www.americandj.com - Ruby Star™ Instruction Manual Page 3
Please carefully read and understand the instructions in this manual
thoroughly before attempting to operate this unit. These instructions
contain important safety information regarding the use and mainte-
nance of this unit. Please keep this manual with the unit, for future
reference.
• 4.9mW Red Laser Diode
• Built-In Hanging Yoke
•
Sound Active with
Internal Microphone
• Fan Cooled
• 16 Patterns
• Music Sensitivity Knob
The
R
uby Star™ carries a 90 day limited warranty. Please fill out the
enclosed warranty card to validate your purchase. All returned service
items whether under warranty or not, must be freight pre-paid and
accompany a return authorization (R.A.) number. If the unit is under
warranty you must provide a copy of your proof of purchase invoice.
Please contact American DJ
®
customer support for a R.A. number.
Caution:
Always replace with the exact same type fuse, unless oth-
erwise specified by an authorized American
DJ
®
technician.
Use of a
different type fuse from that which is recommended may cause fire or
electric shock and will void the manufactures warranty.
Warning:
If you continue to blow fuses, STOP using the unit. Contact
customer support for further instructions, you may have to return the
unit for servicing. Continuing to use the unit may cause serious dam-
age.
Fuse Replacement:
Disconnect the unit’s main power supply.
Use a flat head screw drive to pry out the fuse holder. When the
fuse holder is exposed remove the old fuse and replace it with a
similar one. The fuse holder comes with a slot for a spare fuse. When
replacing and checking the fuse, be sure to check the fuse that has
the metal ends completely exposed.
Safety Issues:
This unit may blow a fuse if the maximum allotted load
of 2 amps (1 amp 220v) is reached.
•
To reduce the risk of electrical shock or  re, do not expose this unit
rain or moisture.
•
Do not spill water or other liquids into or on to your unit.
•
Do not attempt to remove or break off the ground prong from the
electrical cord. This prong is used to reduce the risk of electrical
shock and  re in case of an internal short. Do not attempt to oper-
ate this unit if the power cord has been frayed or broken.
•
Disconnect from main power before making any type of connection.
•
Do not remove the cover under any conditions. There are no user
serviceable parts inside.
•
Always be sure to mount this unit in an area that will allow proper
Always be sure to mount this unit in an area that will allow proper
ventilation. Allow about 6” (15cm) between this device and a wall.
•
Do not attempt to operate this unit, if it becomes damaged.
•
This unit is intended for indoor use only, use of this product out-
doors voids all warranties.
•
During long periods of non-use, disconnect the unit’s main power.
•
Always mount this unit in safe and stable matter.
Always mount this unit in safe and stable matter.
•
Power cords should be routed so they are not likely to be walked
on, pinched by items placed upon or against them.
• Cleaning -The fixture should be cleaned only as recommended by
the manufacturer. See page 6 for cleaning details.
•
Heat -The appliance should be situated away from heat sources
such as radiators, heat registers, stoves, or other appliances
(including amplifiers) that produce heat.
•
The fixture should be serviced by qualified service personnel when:
A.
The power-supply cord or the plug has been damaged.
B.
Objects have fallen, or liquid has been spilled into the unit.
C.
The unit has been exposed to rain or water.
D.
The unit does not appear to operate normally or exhibits a
marked change in performance.
DANGER
VISIBLE LASER RADIA
TION
VISIBLE LASER RADIATIONVISIBLE LASER RADIA
-A
VOID DIRECT
-AVOID DIRECT-A
EYE EXPOSURE
VOID DIRECT EYE EXPOSUREVOID DIRECT
LASER DIODE
WA
VELENGTH : 635~650 nm
WAVELENGTH : 635~650 nmWA
Max Output : <4.9mW
Class IIIa Laser Product
!
!
Ruby Star™ Warranty Registration
Ruby Star™ Features
Ruby Star™ General Instructions Ruby Star™ Specifications
Ruby Star™ Fuse Replacement

©
American DJ
®
- www.americandj.com - Ruby Star™ Instruction Manual Page 5
©
American DJ
®
- www.americandj.com - Ruby Star™ Instruction Manual Page 6
1.
Audio Sensitivity Knob -
Audio Sensitivity Knob -
This adjust audio sensitivity of the
internal microphone (2). Turning the sensitivity knob in the clockwise
direction will increase the sensitivity to sound. Turning the knob in
the counter clockwise direction will decrease the  xture’s sensitivity
to sound. If the knob is turned completely in the counter-clockwise
direction the sound sensitivity function will turn off.
2.
Microphone -
Microphone -
This microphone receives external low frequencies
to trigger the unit in Sound-Active mode. This microphone is designed
to receive low frequency sounds only, tapping on the microphone and
high pitch sounds may not trigger the unit.
3.
Power Cord Connection -
Power Cord Connection -
This connection is used to supply main
power to the  xture. Use only the supplied I.E.C. power cord. Be sure
the main power matches the required power of your  xture. The rated
power requirements are clearly marked on the rear panel of the unit.
4.
Fuse Holder -
Fuse Holder -
This housing stores the 2 amp GMA protective
fuse. Always replace with the exact same type fuse, unless otherwise
instructed, by an authorized American DJ
®
service technician.
Power Supply:
This unit is available in either 120v or 220v option.
Before plugging your unit in be sure the source voltage in your area
matches the required voltage for your American DJ
®
Ruby Star.™
Please refer to the power lable on the rear panel of the unit.
General Operation:
This fixture is designed to operate as a stand
alone unit. The Ruby Star™ is ready to be plugged in out of the box.
There is no power switch, after plugging the unit in a power outlet the
laser will immediately begin to cycle through the many built in pat-
terns (provided there is an ample amount of sound to trigger the unit).
The unit comes with several built-in patterns that automatically cycle
through when the unit is operating, the patterns may not be selected
manually. If the unit does not turn on after the unit has been plugged
in, be sure the fuse has not blown and the unit is properly plugged in
to a matching wall outlet. If problem continue to persist, please con-
tact customer support for further instructions.
Sensitivity Knob:
A sound sensitivity knob is located on the rear
of the unit. Use this knob to regulate the amount of sound it takes to
trigger the unit. Turning the knob in a clockwise direction will increase
the units sensitivity to sound, turning the knob in a counterclockwise
direction will decrease the units sensitivity. Turning the knob com-
pletely to the counter-clockwise direction will turn off the sound-
active mode.
Fixture Cleaning:
Due to fog residue, smoke, and dust cleaning
the external lenses should be carried out periodically to optimize light
output.
1.
Use normal glass cleaner and a soft cloth to wipe down the out-
side casing.
2.
Clean the external optics with glass cleaner and a soft cloth every
20 days.
3.
Always be sure to dry all parts completely before plugging the
unit back in.
Cleaning frequency depends on the environment in which the fixture
operates (I.e. smoke, fog residue, dust, dew). In heavy use we rec-
ommend cleaning on a monthly basis. Periodic cleaning will ensure
longevity, and crisp beam output.
SOUND
MI
N M
IN
LEVEL
FUSE
AC 100-120V
AC 200-240V
Model
:
Ruby
S
tar
Serial No : ____________
Power
:
___________
Fuse
:
___________
Bulb
:
___________
DANGER
VISIBLE LASER RADIA
TIO
VISIBLE LASER RADIATIOVISIBLE LASER RADIA
N
-A
VOID DIRECT
-AVOID DIRECT-A
EYE EXPOSUR
VOID DIRECT EYE EXPOSURVOID DIRECT
E
LASER DIODE
WA
VELENGTH : 635~650 nm
WAVELENGTH : 635~650 nmWA
Max Output : <4.9m
W
Class IIIa Laser Product
1
4
3
2
Ruby Star™ Control & Functions Ruby Star™ Operation
Ruby Star™ Cleaning

©
American DJ
®
- www.americandj.com - Ruby Star™ Instruction Manual Page 7
©American DJ®
American DJ World Headquarters:
4295 Charter Street Los Angeles, CA 90058 USA
Tel: [phone] / Fax: [phone]
Web: www.americandj.com / E-mail: [email protected]
Model: Ruby Star™
Voltage:
120v~60Hz or 220v~50Hz
Laser:
4.9mW Red
Fuse:
2A GMA/120V or 1A GMA/220v
Dimensions:
14.75” H x 5.5” W x 7.25” D
Weight:
6 Lbs.
Duty Cycle:
None
Ventilation:
Fan Cooled
Warranty:
90 Days
Please Note:
Speci cations and improvements in the design
of this unit and this manual are subject to change without any
prior written notice.
90 DAY LIMITED WARRANTY
A. American DJ
®
hereby warrants, to the original purchaser, American DJ
®
products to be
free of manufacturing defects in material and workmanship for a period of 90 days from the
date of purchase. This warranty shall be valid only if the product is purchased within the
United States of America, including possessions and territories. It is the owner’s respon-
sibility to establish the date and place of purchase by acceptable evidence, at the time
service is sought.
B. For warranty service, send the product only to the American DJ
®
factory. All shipping
charges must be pre-paid. If the requested repairs or service (including parts replacement)
are within the terms of this warranty, American DJ
®
will pay return shipping charges only
to a designated point within the United States. If the entire instrument is sent, it must be
shipped in its original package. No accessories should be shipped with the product. If any
accessories are shipped with the product, American DJ
®
shall have no liability whatsoever
for loss of or damage to any such accessories, nor for the safe return thereof.
C. This warranty is void if the serial number has been altered or removed; if the product is
modi ed in any manner which American DJ
®
concludes, after inspection, affects the reli-
ability of the product; if the product has been repaired or serviced by anyone other than
the American DJ
®
factory unless prior written authorization was issued to purchaser by
American DJ
®
; if the product is damaged because not properly maintained as set forth in
the instruction manual.
D. This is not a service contract, and this warranty does not include maintenance, cleaning
or periodic check-up. During the period speci ed above, American DJ
®
will replace defec-
tive parts at its expense, and will absorb all expenses for warranty service and repair labor
by reason of defects in material or workmanship. The sole responsibility of American DJ
®
under this warranty shall be limited to the repair of the product, or replacement thereof,
including parts, at the sole discretion of American DJ
®
. All products covered by this war-
ranty were manufactured after January 1, 1990, and bear identifying marks to that effect.
E. American DJ
®
reserves the right to make changes in design and/or improvements upon
its products without any obligation to include these changes in any products theretofore
manufactured.
F. No warranty, whether expressed or implied, is given or made with respect to any acces-
sory supplied with products described above. Except to the extent prohibited by applicable
law, all implied warranties made by American DJ
®
in connection with this product, includ-
ing warranties of merchantability or  tness, are limited in duration to the warranty period
set forth above. And no warranties, whether expressed or implied, including warranties of
merchantability or  tness, shall apply to this product after said period has expired. The
consumer’s and or Dealer’s sole remedy shall be such repair or replacement as is expressly
provided above; and under no circumstances shall American DJ
®
be liable for any loss or
damage, direct or consequential, arising out of the use of, or inability to use, this product.
G. This warranty is the only written warranty applicable to American DJ
®
Products and
supersedes all prior warranties and written descriptions of warranty terms and conditions
heretofore published.
H. All lamps and fuses are not covered under this warranty.
Ruby Star™ Warranty Ruby Star™ Specifications