American DJ MEGA STROBE/DMX User manual

™750W DMX Strobe Light
MEGA STROBE/DMX
American DJ®Instruction Manual
SPECIFICATIONS: MODEL - Mega Strobe/DMX™
Weight: 9 lbs.
Size: 12" x 8.75" x 6"
Lamp: ZB-300
Voltage: 120V/60Hz
Working Position: Any Safe position
Fuse: 16A
Power Draw: 750W
Connection: XLR
Flash Rate: 15 flashes per second flash
Tube Life: 500,000 Flashes
Affordable Quality Lighting Products from American DJ ®Los Angeles, CA. 90058 USA
CAUTION! Read instructions before installing or plugging unit in.
Thank you for purchasing the Mega Strobe/DMX!
Here are a few tips before getting started.
General Functions (REAR):
A. POWER INPUT: AC 120V/60Hz, 16A
B. CIRCUIT BREAKER: 16A
C. POWER INDICATOR: Lights when power is ON
D. DMX DIP SWITCH SETTINGS: By assigning dip
switch 10 to ON, unit goes to “DMX Pack Mode”.
Follow DMX addressing printed on the rear of
this Instruction Manual for desired speed and
dimming settings. By assigning dip switch 10 to OFF,
unit goes to “DMX Self-test Mode”. Follow “Self-test” settings printed on rear to select desired chase.
E. DMX INDICATOR: Indicates when DMX is effective.
F. DMX SIGNAL OUTPUT: XLR female socket used to connect to other Mega Strobe/DMXs.
G. DMX SIGNAL INPUT: XLR male socket used to receive DMX signals.
Operating Instructions:
1. Unit is ready to be hung or set on flat surface. We suggest the use of safety cable (not provided) when hanging
unit. The Mega Strobe/DMX plugs direct into 120V. Make sure power configuration is correct.
2. Plug in power cord to turn unit ON.
3. This unit has two operation modes: “DMX Self-test Mode” and “DMX Pack Mode”.
4. Switch dip switch 10 to the OFF position, the unit goes to “DMX Pack Mode”. There are 2 “Self-test” modes:
AUTO and MANUAL. Set dip switch 9 to OFF, it performs “AUTO Self-test”. When strobe flashes within the
dimming range from 0% to 100% and then from 100% to 0%, a slower or faster speed will be executed.
The strobe will flash at regular speed corresponding to the dimmer duration. Set dip switch 9 to ON, it will then
A
B
CE F
G
D

Mega Strobe/DMX Instructions p.2
Operating Instructions (Cont.):
enter “MANUAL Self-test”. Dip switch 1, 2, 3, and 4 may assigned to control Speed (1 = slowest, 4 = fastest).
Dip switch 5, 6, 7 and 8 may be assigned to control dimming (5 = dimmest, 8 = brightest).
5. Switch dip switch 10 to the ON position, unit goes to “DMX Pack Mode”. Follow “DMX Pack Mode” address
settings below for desired speed and dimming.
6. For safety disconnect power cable when not in use.
WARNING:
• Avoid direct eye exposure.
• Disconnect from main power before replacing lamps or servicing unit.
• Always with same lamp and fuse.
• To prevent fire or shock hazard, do not expose unit to rain or moisture.
DIP SWITCH SETTINGS:
“DMX PACK MODE” “SELF-TEST MODE”
“MANUAL SELF-TEST MODE”
Speed and dimming are classified as 16 levels respectively.
SPEED DIMMING
DO NOT OPERATE CONTINUOUSLY ON
MAXIMUM SPEED FOR MORE THAN
15 MINUTES!
Maintenance:
Caution! Never open unit when in use.
Always disconnect main power before serv-
ing or replacing lamp. Wait 30 minutes
before changing the lamp. Remember always
replace same lamp and fuses. There are no
serviceable parts!
Lamp replacement:
Disconnect power. Remove the front cover and
replace lamp with model ZB-300. Do not touch
new lamp with bare hands. Use a clean cloth
when handling lamp. This will ensure long life of
lamp.
Service:
For service, please call your American DJ®
dealer. Make sure you send in your warranty
card!