American Standard 410 User manual

J24
Revised
BARRIER FREE
© 2008 AS America Inc.
FINISHED
WALL
OR
SPLASH BACK
467mm
(18-3/8)
610mm
(24)
191mm
(7-1/2)
70mm
(2-3/4)
38mm
(1-1/2)
203mm
(8) OPTIONAL
FINISHED
FLOOR
337mm
(13-1/2)
1-1/4 O.D.
TAILPIECE
1-1/4 O.D.
WASTE
203mm
(8)
*
178mm
(7)
16mm
(5/8)
273mm
(10-3/4)
*
COUNTERTOP (BY OTHERS)
200mm
(7-7/8)
29mm
(1-1/8)
SUPPLIES
AS REQ'D 787mm (31)
848mm (33-3/8)
848mm
(33-3/8)
51mm
(2)
610mm
(24)
152mm
(6)
MAX.
BARRIER FREE
CLEARANCE
686mm
(27)
MIN.
203mm
(8)
MIN.
229mm
(9)
MIN.
ELLISSE PETITE™
COUNTERTOP SINK
VITREOUS CHINA
ELLISSE PETITE™ COUNTERTOP SINK
• Petite stylish countertop sink made from
vitreous china
• Self-rimming with cutout template supplied
• Rear overow
• Large deck area
Shown with 8871.802 Amarilis faucet with
Fabian handles (not included)
❏ 0411.039 Faucet holes on 8" (203mm) centers
(illustrated)
❏ 0410.021 Faucet holes on 4" (102mm) centers
❏ 0411.047 Center hole only
Nominal Dimensions:
610 x 467mm
(24" x 18-3/8")
Bowl sizes:
457mm (18") wide
305mm (12") front to back
165mm (6-1/2") deep
Compliance Certications -
Meets or Exceeds the
Following Specications:
• ASME A112.19.2M for
Vitreous China Fixtures
To Be Specied:
❏ Color: ❏ White ❏ Bone
❏ Linen ❏ Silver
❏ Fawn Beige
❏ Black
❏ Faucet*:
❏ Faucet Finish:
❏ Supplies:
❏ 1-1/4" Trap:
* See faucet section for additional models available
MEETS THE AMERICANS WITH DISABILITIES ACT GUIDELINES
AND ANSI A117.1 ACCESSIBLE AND USABLE
BUILDINGS AND FACILITIES - CHECK LOCAL CODES.
Install lavatory 864mm (34") from finished floor.
Lavatory installed 51mm (2") minimum from front edge
of countertop provides 686mm (27") knee clearance area.
NOTES:
* DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND “P" TRAP
ARE SUGGESTED.
FOR COUNTERTOP CUTOUT AND INSTALLATION INSTRUCTIONS USE
TEMPLATE SUPPLIED WITH SINK.
FITTINGS NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED
SEPARATELY.
SEALING COMPOUND SUPPLIED BY OTHERS.
IMPORTANT: Dimensions of xtures are nominal and may vary within the
range of tolerances established by ANSI Standard A112.19.2.
These measurements are subject to change or cancellation. No responsibility
is assumed for use of superseded or voided pages.
Revised 2/08