American Standard Chandler Double Bowl Sink 7048.001 User manual

G11
© 2008 AS America Inc. Revised 6/06
CHANDLER™
DOUBLE BOWL SINK
DUPONT CORIAN®
CHANDLER™ DOUBLE BOWL KITCHEN SINK
• Dupont Corian® surface
• Double bowl design
• Top mount
• Silicone sealant supplied
• Available in center hole only, 3, or 4 faucet
hole conguration
❏ 7048.001 Center hole only
❏ 7048.803 3 hole
❏ 7048.804 4 hole
Nominal Dimensions:
914 x 559 x 254mm
(36" x 22" x 10-1/2")
Bowl sizes:
Right Hand: 359mm (14-1/8") wide
413mm (16-1/4") front to back
203mm (8") deep
Left Hand: 432mm (17") wide
476mm (18-3/4") front to back
254mm (10") deep
Compliance Certications -
Meets or Exceeds the Following Specications:
• ANSI Z124.6 for Non-Metallic Sinks
* See faucet section for available models
To Be Specied:
❏ Color:
❏ Faucet*:
❏ Faucet Finish:
❏ Basket Strainer: 4331.013
❏ Soap Dispenser: 4503.115
❏ Traps:
NOTES:
* SELF-RIMMING: FOR COUNTERTOP CUTOUT AND INSTALLATION
INSTRUCTIONS USE TEMPLATE SUPPLIED WITH SINK.
FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.
PROVIDE SUITABLE REINFORCEMENT FOR ALL WALL AND
COUNTERTOP SUPPORTS.
IMPORTANT: Dimensions of xtures are nominal and may vary within the
range of tolerances established by ANSI Standard Z124.6
These measurements are subject to change or cancellation. No responsibility
is assumed for use of superseded or voided leaet.
7-1/8"
(181mm)
(2) 1-1/2" O.D.
TAILPIECE
10-1/8"
(257mm)
5-3/4"
(146mm)
Y
COUNTERTOP
(BY OTHERS)
5-3/4"
(146mm) 36" (914mm)
SUGGESTED
FINISHED
FLOOR
8-1/8"
(206mm)
3/8"
(10mm)
4"
(102mm)
HOT COLD
FINISHED WALL OR
SPLASH BACK
4"
(102mm)
3-1/2"
(89mm) DIA.
4-1/4"
(108mm)
4"
(102mm)
11"
(279mm)
18"
(457mm) 1-3/8"(35mm) DIA.
HOLES TYP.
8-3/4"
(222mm)
C/L
SPRAY
7048.804
4 HOLE
VARIATION
1-3/4"
(44mm) DIA.
2"
(51mm) OPTIONAL
22"
(559mm)
CUTOUT
NOTE
*
1-1/2" REF.
(38mm)
SEALING
COMPOUND
36"
(914mm)
4-1/2"
(114mm)
9-1/2"
(241mm)
1" (25mm)
RAD. TYP.