American Standard 61000NS-WT User manual

Replace dampers for the S&C
S&C disassembling
1) Use screwdriver, knife or any similar sharp tool to take out the buckle.
2) Use screwdriver, knife or any similar sharp tool to push soft-close set towards the right side, until
expose the small hole on the press button, stick the hole and then push it towards right side until
can not move further.
3) Lift up the left side of the seat slightly (Don’t use too much power to avoid damage of S&C, lift it
up to the point the seat can leave the cover. ), and then pull out the seat towards the left side to
finish the disassembling.
Black one with ribs
is left soft-close set
White one without ribs
is right soft close set

Replace dampers for the S&C
S&C assembling
Small hole of
soft-close set Wide side rib
1) Put left and right soft-close set into the seat, make sure the small hole of the soft-close set and the
wide side rib is upward.
2) Assemble right soft-close set, set small hole and wide side rib upward and then push it into the
cover.
3) Assemble left soft-close set, set small hole and wide side rib upward and then push it into the
cover.
4) Put the buckle onto the buckle hole, use a hammer to knock it slightly until it is locked tightly, and
then finish the assembling.
88153-A