AMP Lighting InfusePro AHS- 630X-4-B-BZ Operating and safety instructions

INSTALLATION & MAINTENANCE GUIDE
Help Hotline:
1-813-978-3900 • Mon-Fri 9am-6pm (EST)
www.amplighting.com
AMP®Low Voltage Landscape Lighting
AMP® InfusePro Thin Integrated Step Light
AHS- 630X-4-B-BZ

AMP®InfusePro Thin Integrated Step Light
AHS-630X-4-B-BZ
INSTALLATION & MAINTENANCE GUIDE
www.amplighting.com
–2–
Important Safety Instructions: Read Before Installation
!
Important Safety Instructions
!
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS
Lighted lamp is HOT!
WARNING – To reduce the risk of FIRE OR INJURY TO PERSONS.
1. Turn off/unplug and allow to cool before replacing lamp.
2. Lamp gets HOT quickly! Contact only switch/plug when turning on.
3. Do not touch the hot lens, guard or enclosure.
4. Keep lamp away from materials that may burn.
5. Do not touch lamp at any time. Use a soft cloth. Oil from skin may
damage lamp.
6. Do not operate the luminaire tting with a missing or damaged shield.
SAVE THESE INSTRUCTIONS
This luminaire is intended for installation in accordance with local codes
and the National Electric Code (NEC). Failure to adhere to these codes and
instructions may result in serious injury, property damage and void the war-
ranty.
These instructions do not intend to cover all variations in installation, oper-
ation maintenance or mounting situations.
1. Make sure that the power is turned OFF before installing or servicing
this luminaire.
2. Warning: risk of electrical shock. Install all luminaires 10 feet (3.05M)
or more from pool, spa or fountain.
3. This luminaire is intended to be used only with a power supply (trans-
former) rated maximum of 300 watts (25 AMPS) at 15 volts.
4. Wiring connections must be made with UL listed wire connectors that
are suitable for outdoor use.
5. Position the low voltage wire and wire connector so that it is located
within 6 inches (15.2 cm) from a building structure, a luminaire or
tting.
6. The main low voltage cable is intended for shallow burial - less than 6
inches (152mm).

[email protected] • 813.978.3900
Product Dimensions
–3–
Package Contents
A. (1) Luminaire
B. (2) Anchors
C. (2) Screws
8.25”
8.25”
AHS-6301-4-B-BZ
AHS-6302-4-B-BZ
AHS-6303-4-B-BZ
8.25”
3.25”
3.25”
3.25”
0.75”
1.5”
0.5”

INSTALLATION & MAINTENANCE GUIDE
–4–
www.amplighting.com
–4–
2
1
AMP®InfusePro Thin Integrated Step Light
AHS-630X-4-B-BZ
Install Luminaire
Note: Anchors are required for
concrete or brick walls. Hold
the luminaire on the wall and
mark two points for the anchors
using the mounting holes as
guides. Then drill the proper
holes using the marks. Insert
the anchors into the drilled
holes.
Attach the luminaire onto the
desired mounting surface and
secure with the screws. Hand
tighten until snug with a screw-
driver.
Screw
Anchor
Luminaire
Wire Connection
Strip both leads from the luminaire pigtail. Using two wire connectors
(sold separately), connect the leads from the luminaire to the main
supply cable leads.
Pigtail
Supply Cables
Wire Connectors
Main Supply Cable

[email protected] • 813.978.3900
–5–

–6–
www.amplighting.com
–6–

–6––6–
[email protected] • 813.978.3900
–7–

IS-AHS-630X-4-B-BZ-ver1.pdf
Specications and product details subject to change without notice.
© Copyright 2020, AMP®Lighting, Lutz FL USA 33549 • All rights reserved.
[email protected] • 813.978.3900
Help Hotline:
1-813-978-3900 • Mon-Fri 9am-6pm (EST)
www.amplighting.com