AMP Lighting FoundationPro Paver Light Operating and safety instructions

–1–
INSTALLATION & MAINTENANCE GUIDE
Help Hotline:
1-813-978-3900 • Mon-Fri 9am-6pm (EST)
www.amplighting.com
AMP®Low Voltage Landscape Lighting
AMP® FoundationPro Paver Light
ASI-9002-F-PG

Package Contents
A. (1) Fixture
Product Dimensions
9”
6”
2.25”
LIGHTED LAMP IS HOT!
WARNING – TO REDUCE THE RISK OF FIRE OR INJURY TO PERSONS.
1. Turn off/unplug and allow to cool before reducing lamp.
2. Lamp gets HOT quickly!
3. Do not touch the hot lens, guard or cowl.
4. Keep lamp away from materials that may burn.
5. Do not touch lamp at any time.
6. Use a soft cloth.
7. Oil from skin may damage lamp.
8. Do not operate the xture with a damaged or missing lens or shield.
Wire Connections
Install Fixture
1
2
Strip both leads from the luminaire pigtail. Using two wire
connectors (sold seperately), connect the leads from the luminaire
to the main supply cable leads.
Determine the location for the
xture. Leave a rectangular slot
in pavers (size: 6”W x 9”L x 2.5”
Deep) and place the xture into
the the slot. It will take the place
of a single paver of equal size.
Pigtail
Fixture
Main Supply Cable
Paver
Wire Connectors
(sold seperately)
–2– –3–
This xture is intended for installation in accordance with local codes
and the National Electric Code (NEC). Failure to adhere to these codes
and instructions may result in serious injury, property damage and void
the warranty.
These instructions do not intend to cover all variations in installation,
operation maintenance or mounting situation.
1. Make sure that the power is turned OFF before installing or servicing
this xture.
2. Warning: this xture is not intended to be installed within 10 feet [3
meters] of a pool, spa or fountain.
3. This xture is intended to be used only with a power supply
(transformer) rated maximum of 300 watts (25 AMPS) at 15 volts.
4. Underground Low Energy Cable must not be buried over 6” (15.2 cm) in
order to connect to the main low voltage cable.
5. Wiring connections must be made with UL Listed wire connectors that
are suitable for outdoor use.
6. Position the wire connector so that it is located within 6 inches (15.2
cm) from a building structure, a luminaire, or tting.
AMP®FoundationPro Paver Light
ASI-9002-F-PG
INSTALLATION & MAINTENANCE GUIDE
Important Safety Instructions: Read Before Installation
!
Important Safety Instructions: Read Before Installation
!
www.amplighting.com [email protected] • 813.978.3900

–4–
Specications and product details subject to change without notice.
© Copyright 2019,AMP® Lighting, Lutz FL USA 33549 • All rights reserved.
[email protected] • 813.978.3900
Help Hotline:
1-813-978-3900 • Mon-Fri 9am-6pm (EST)
www.amplighting.com