AMP Research BedStep AMP 75314-01A User manual

Chevy Silverado / GMC Sierra
1500 2014-2015
Torque wrench
18mm T25
20-03797-10
19-03783-90
18mm
15-03962-90 13mm
33 ft-lbs / 44 Nm
PART NUMBER:
AMP 75314-01A
15-03961-90
15-03963-90
18mm 13mm
19-03901-90
19-03900-90
19-03377-90
11-03639-90
19-03901-90
15-03948-90
1 2
3 4
Remove factory nuts
Install bracket to truck Torque nuts
to 59 ft-lbs / 80Nm
Insert threaded bracket (19-03963-90) into bum-
per and assemble bracket (19-03961-90) with
supplied bolt. Use slotted end of bracket at
bolt.

T25
13mm
Install bracket (19-03962-90) to upper bed panel. Slotted side will mount on bed panel. See im-
age for bracket orientation. Use provided bolts and nuts to mount and torque bolts to 16 ft-lbs /
22Nm
Install step pad. Offset pad to rearward position Torque 3 PT screws to 5 ft-lbs /6Nm
Note: Overtightening screws may
damage step pad.
5
67
8

Congratulations on the purchase of your
AMP RESEARCH BedStep®
Here’s what you should know...
OPERATION
TheAMP Research BedStep®is foot operated and deploys and retracts with a nudge of your foot.
To deploy, press down using your left foot, on the foward outside corner of the step pad.
To retract, gently kick the underside of the step pad.
Max Load Capacity: 300lbs.
Always use appropriate hand holds when stepping up to or down from your truck’s cargo bed.
MAINTENANCE TIPS
The step pad surface and linkage arms can be washed with mild soap and water using a soft brush or
sponge to dislodge any mud, dirt or accumulated road grime. Rinse with fresh water.
To prevent slipping, avoid applying waxes, lubricants or protectants like Armor All®to the step surface.
ATTENTION!
BEDSTEP SHOULD ALWAYS BE STOWED IN THE RETRACTED POSITION WHEN DRIVING.