AMS TMD2620 User manual

Quick Start Guide
TMD2620 EVM
TMD2620 Proximity Sensor Evaluation Module
Version 1.0

page 2/5
Contents
1 Out of the Box ......................................................................................................................3
2 Software Installation.............................................................................................................3
3 Connect Hardware ...............................................................................................................3
4 Start the Application.............................................................................................................3
5 Contact and Support............................................................................................................5

page 3/5
1 Out of the Box
Each TMD2620 Evaluation Kit comes with the following components:
•Controller board v2.2-A
•TMD2620 Daughterboard
•USB Cable with A connector and mini B connector
•Flash Drive with Application Software and Documents
Figure 1 TMD2620 EVM Kit
2 Software Installation
Most PCs should have one or more Universal Serial Bus (USB) ports. Install the ams flash drive
into an unused USB port. Double-click the Setup.exe file on the flash drive, or click Start -> Run
and type E:setup.exe and press Enter. IMPORTANT: Use the appropriate drive letter in the above
command to install the software. Flash Drive will commonly be assigned the next available drive
letter for example C: hard drive D: CD-ROM E: flash drive
The Setup Wizard will open and guide you through the installation of the TMD2620 host software,
(Figures 2 through 8). To re-install, run the setup.exe program again. To remove the software from
your computer (Figure 9), select ams -> TMD2620 EVM -> Uninstall TMD2620 EVM or use the
Windows Control Panel.
3 Connect Hardware
Plug the TMD2620 Daughterboard into the Controller board. (Figure 1) Always use ESD procedures
when handling the EVM.
Using the enclosed USB cable, plug the mini-B connector into the EVM module. Using the other
end of the cable, plug the USB A-connector into a USB port on the computer.
4 Start the Application
To start the application select ams->TMD2620 EVM->TMD2620 EVM on the All Programs menu.

page 4/5
Figure 2 Welcome Screen
Figure 3 Liability Disclaimer
Figure 4 Select Installation Folder
Figure 5 Select Start Menu Folder
Figure 6 Installation in Progress
Figure 7 Information Screen

page 5/5
Figure 8 Installation Completed Successfully
Figure 9 Remove Installation
5 Contact and Support
For detail in using the TMD2620 EVM please refer to the User’s Guide included in the documents.
If any technical difficulties are encountered, use the Tech Support page at www.ams.com/Support
to submit a technical support request anytime or call [phone] (main) M-F 8AM-5PM CST
You may also use www.ams.com to find worldwide local representatives in your area.