Anchor Economy Tent International XP Series User manual

XP Series Frame Tent Assembly Instructions
Recommended equipment and manpower for installa on:
Two experienced installers can normally install these products in thirty minutes or less.
One or two 4’or 6’ step ladders.
Gloves
Approved safety head gear
Ground cover to protect the top
Prior to laying out this or any other ETI product be sure you have thoroughly inspected the area
for any overhead or underground obstruc ons the may interfere with the safe installa on of
this product.
1. Place the 4 eaves along with the 4 corner weldments in a square configura on on the
ground where the frame will be erected.
2. Slide the eaves into weldments locking them into posi on using the snap bu ons
crea ng a ridged perimeter.
3. Place the first cable diagonally across the frame and slide the loop ends over the steel
posts provided at each corner. Making sure the second cable is on the top of the first
cable repeat this process. You may have to elevate the corner slightly to a ach the last
loop.
TF: 800-438-3226 |EM: [e-mail] |economytent.com

4. Lay the top over the frame pulling the web loops in the corner over the steel rod to hold
the top in place.
5. Raise your first corner and lock the upright into posi on using the provided snap bu on
in the corner weldment. Stand up leeward side (the side sheltered from the wind) first
whenever possible and as you install each upright it is advisable to a ach your top
tensioning strap and leave in a loose se ng. It is also recommended that if there is a
wind condi on of any kind you put your anchoring system in place and a ach the guys
to the anchoring system as you erect the frame.
6. From underneath the frame go to the low side. Place the center pole pin carefully
through the opening provided at the peak of the tent and place the pulley in the center
pole base over the top cable. You can now slide the center pole up the cable un it
reaches the posi on where the cables cross. Pull down slightly on the bo om cable
locking the base in posi on. At this point install the wire lock pin through the hole
provided at the bo om of the pole base to secure the base to the cables.
TF: 800-438-3226 |EM: [e-mail] |economytent.com
XP Series Frame Tent Assembly Instructions, continued

7. A er securing the center pole con nue standing up the remaining two corners and
aaching the top tensioning straps.
8. While tensioning the top to the frame do not over hten in any one corner. Make
adjustments in the tension so as to keep the top as square and as evenly tensioned as
possible.
9. You may now a ach the strap and buckle to the frame eave if the top has this feature.
10. Please be sure that the frame is securely anchored as well as guyed out for stability.
TF: 800-438-3226 |EM: [e-mail] |economytent.com
XP Series Frame Tent Assembly Instructions, continued