Appleton AES1501 User manual

Mini Dry Bath with Heated Lid
AES1501
Introduction:
Thank you for purchasing the Appleton Mini
Dry Bath with heated lid. Please read this
manual thoroughly prior to operating the
instrument.
The Mini Dry Bath features a heated lid for
protecting samples against unwanted
condensation and evaporation. The block and lid
temperature can be controlled independently,
making this the ideal choice for the most
temperature sensitive applications.
Please read this manual carefully prior to
operation. Any attempt to use this instrument
that is not in accordance with the manual, may
cause harm or injury to the user.
Installation:
Place the Mini Dry Bath with HL on a flat and
level surface nearby an electrical outlet. It
should not be near a heat source or in direct
sunlight.
Warning and Hazard Signs:
Caution, Hot Surface Caution
Operation:
- Attach the power cord and place the power
switch into the on “-” position.
- Lift the lid of the block and install the
appropriate block (purchased separately).
- Press the “SET” key and select the desired
block temperature using the up and down
arrows.
- Press the “SET” key again and select the
desired lid temperature using the up and
down arrows.
- The instrument will now quickly heat to the
desired temperature. The right side of the
display will read “NOT OK” until the desired
temperature has been reached in both, the
block and lid. The display will then read
“OK”
- Once the unit is up to temperature, load your
samples into the block and lower the lid.
CAUTION: Hot surfaces, especially on
the block, can cause serious injury/burns.
CAUTION: Do not put water or liquids into
the well as shock, serious injury and death
may occur.
CAUTION: Do not heat flammable or
explosive substances as serious injury and
death may occur.
To disconnect power at any time, the
main cord on the AC Adaptor is to be used
as the Mains Disconnect.
Specifications:
Temp. Range: Ambient +5 to 100°C
Temp. Accuracy: +/- 0.3°C
Temp. Increments: 0.1°C
Temp. Uniformity: +/- 0.2°C
Block Construction: High Grade Aluminum
Environment: 4°C to 35°C
Dimensions: 4.4 x 5.9 x 4 in.
11.2 x 15 x 10 cm
Weight: 2 lbs / 0.9kg
Electrical: 24v DC, 2A converted from
120V to 240V, 50-60 Hz
Cleaning and Maintenance:
The aluminum blocks can be removed for
cleaning by using the included block lifter. Once
removed, the blocks can be cleaned with
isopropyl alcohol or can be sterilized in an
autoclave at 121°C for 20 min.
The instrument can be cleaned with a damp cloth
or isopropyl alcohol. The user is responsible for
the appropriate decontamination in case of
spillage of hazardous material inside the case of
the instrument. NOTE: The user is responsible for

only using the cleaning agent listed above.
The use of any decontamination or cleaning
agents that could cause a HAZARD as a
result of a reaction with parts of the
equipment or with material contained in it is
prohibited. If there is any doubt regarding
the compatibility of a specific
decontamination or cleaning agent, please
contact the manufacturer.
Service and Contact:
Appleton Woods distribute these products in
the UK; for customer service or technical sup
port, please contact info@appletonwoods.c
o.uk or call on 0121 4587740.
New Lindon House
Catesby Park
Kings Norton
Birmingham B38 8SE