Aprilaire 1510 User manual

Model 1510 Media Air Cleaner
Installation Instructions
1. High voltage may cause serious
injury from electrical shock.
Disconnect power to the
furnace/air handler before
starting installation.
2. Sharp edges may cause injury
from cuts. Use care when cutting
and handling sheet metal.
WARNING
1. To prevent component failure, do not install the air cleaner on the warm
air supply or in an area where the temperature may exceed 140°F. This
may include areas above heat exchangers in downflow furnaces or above
exhaust flues in lowboy furnace cold air returns.
2. Installation must be done by a qualified heating and air conditioning
professional. Read instructions thoroughly before beginning installation.
3. Do not install air cleaner downstream of a UV light. UV lamps will cause
degradation of the filtering media.
CAUTION
SPECIFICATIONS
DIMENSIONS
TABLE 1 – Dimensions (inches)
Model A B C D E F G H
1510 28-3/4 28-1/16 23-7/8 6-3/4 30-1/16 23-7/8 28-3/4 31
A
B
without door
C
D
E
with door
F
G H
90-1333
Model 1510
Airflow Capacity up to 3000 CFM maximum
Replacement Media Model 510 or 513 with SelfSeal™
Max. Equipment Weight Cabinet will support 400 lb. static load
Air Cleaner Operating Environment Temperature: 0°F
– 140°F. Humidity: 0 – 90% non-condensing.

INSTALL THE AIR CLEANER CABINET
1. Leave sufficient space in front of the air cleaner for the removal of the filtering media (see Figure 1).
2. DO NOT INSTALL DOWNSTREAM OF A UV LIGHT. UV lamps will cause degradation of the filtering media.
3. Figure 1 shows typical application of the air cleaner mounted to a horizontal system.
4. Figure 2 shows the air cleaner mounted to the side of a geothermal heat pump.
LOCATING THE AIR CLEANER
FIGURE 1 FIGURE 2
29"
45° MAX
AIR FLOW
10-10998 90-1769
2

2. Remove the air cleaner door from the outer housing and pull out
the filtering media.
3. If replacing an existing filter, remove the filter and thoroughly
clean the blower compartment.
4. Use screws (field supplied) to mount the outer housing to the
furnace/air handler. There is no inlet or outlet side on the outer
housing (the outer housing can be mounted on the left or right side
of the furnace/air handler).
5. Mount the return ductwork to the outer housing.
6. Seal all connections using mastic, foil tape or silicone based caulk.
7. Install the filtering media (see Figure 3).
8. Install the door.
9. Reconnect power to the furnace or air handler at the electrical
service panel.
INSTALLATION
120 Volts may cause serious injury from electrical shock.
Disconnect power to the furnace/air handler before
starting installation. Leave power disconnected until
installation is completed.
WARNING
1. Disconnect power to the furnace or air handler at the electrical
service panel. FIGURE 3
Expand clean filter.
Align filter in top and bottom rails
and slide into place. Reinstall door.
Install filter with Air Flow pointing
toward Furnace or Air Handler.
3

P.O. Box 1467 • Madison, WI 53701-1467 • Phone: [phone] • Fax: [phone] • www.aprilairepartners.com
10010397 6.13
B2701303A
Printed in U.S.A.
© 2013 Aprilaire – A division of Research Products Corporation