Aqua ADLASN User manual

29/04/11 ADSP7000524 Rev.1 1 / 5
ADLASN OPERATING INSTRUCTIONS

29/04/11 ADSP7000524 Rev.1 2 / 5

29/04/11 ADSP7000524 Rev.1 3 / 5
General Comments
The aim of the manual is to provide you with all the necessary information for a proper installation and maintenance in
order to give you optimum results whilst in operation.
For this reason it is really important reading with attention the instructions given below since they furnish all the
indications necessary for the sureness of the installation, use and maintenance.
This manual has to be preserved with care to be consulted in whatever occasion.
he electrical
plant.
Do not leave the equipment exposed to the action of the atmospheric agents.
The equipment has to be operated from skilled person.
In case of improper functioning of the panel switch off and contact our technical assistance for any necessary
repairs.

Design standard
In order to obtain an high trustworthiness and a lasting functioning of the product it is necessary to follow with
attention our manual particularly in reference with the maintenance.
The Producer declines all responsibility in reference with whatever intervention on the equipment
from not skilled personnel.
Technical Characteristics
Material:
PVC PP NBR
Max. Temperature:
50°C
Lance(B)
A (ADJUSTABLE)
H400

H490

H700

H940

H1420

Probe level:
Material: PP
Electrical characteristics
V Max: 250 VAC
Max current: 0,5A
P Max: 10W
Installation on A-TANK
Using a cup Cutter drill the upper tank (as in Fig. 1).
Mount rubber sleeve D = 40mm
Mount ring D = 34 mm
Adjust the position of the junction block pipe according to the
height tank and then tighten the knob Boarding (Fig. 2).

29/04/11 ADSP7000524 Rev.1 4 / 5
In fitting with the sleeve, after entering the lance in the hole, make downward pressure until the lance reaches the
bottom of the tank (Fig. 3).
In fitting with ring insert the spear into the hole, hand tighten the ring,
from inside the tank until the lance reaches the bottom of the tank (Fig. 4).
If the dosing pump is equipped with purge connect the pipe connecting the purge
of the junction block pipe.
The product will be well in excess channelled into the reservoir (Fig. 5).
Sondering for extracting connector ADSP6000454
In case you need to connect the lance throgh a connector,
you shoudl solder the cable on input 3 and 4 (see fig.6)
ADSP6000454
Maintenance
Check the upward mobility of float (Fig. 7).
en the cables of the
probe when the float is low

and if necessary with compressed air.
After the implementation of the European Directive 2002/96/EU in the national legal system, the following applies:Electrical and electronic devices may
not be disposed of with domestic waste. Consumers are obliged by lak to return electrical and electronic devices at the end of their service lives to the
public collecting points set up for this purpose. Detalis to this are defined by the national law of the respective country. This symbol on the product, the
instruction manual or the package indicates that the product is subject to these regulations. By recycling, reusing the material or other forms of utilising
old devices, you are making an important contribution to protecting our environment
Fig. 3
Fig. 4
Fig. 5
Fig. 7
Fig. 6
Fig. 5

29/04/11 ADSP7000524 Rev.1 5 / 5
ADLASM