Aqualuma TRIM TAB LIGHT User manual

*Please note red wire is positive and black is negative
Limited Warranty
(Please pass on to the vessel owner)
Aqualuma warrants all of its product range with a Three (3) year warranty to be free of defects in
workmanship and materials.
Aqualuma warranty will be deemed void if the product is improperly maintained or as a result
of misuse, neglect, improper installation or natural disasters such as ood, re, lightning or
unauthorized repairs or modications.
Aqualuma will replace at its option any product or part free of charge upon return of the defective
item and will pay for return freight within warranty period.
Aqualuma’s liability in all claims and events is limited to and shall not exceed the purchase price of
the Aqualuma product. No armation of fact or warranty expressed or implied other than that set
out in the warranty statement above is made or authorized by Aqualuma.
Aqualuma disclaims any liability claims that are due to misapplication, improper selection or
misuse. Any liability for consequential or accidental damages is expressly disclaimed.
AMG ( QLD) PTY. LTD.Trading as Aqualuma
Unit 4, 54 Siganto Drive
Helensvale
4212 Qld Australia
Email : [email protected]
Web: www.aqualuma.com
Fitting Instructions for
TRIM TAB LIGHT

Trim Tab Fitting Instructions
All Aqualuma lights have been tested before shipping.
It is recommended that you use a qualied boat builder to work out placement and tting
of your new underwater lights.
You will require the following to install your new Aqualuma lights: -
6 mm/1/4’drill, 5 or 6 cable/zip ties and a Fuse or Circuit Breaker
Step 1
With boat on hardstand or trailer work out where to t light unit to Trim tab or angle
bracket and mark hole centres as set out below.
Standard Trim Tab Light
Step 2
Drill the 2 holes required to mount the unit to theTrimTab or Bracket.
Step 3
Using the 2 nylock nuts and bolts supplied attach the unit to the TrimTab or Bracket and
tighten until just tight ( do not over tighten ) the nut and bolt need only to be tight
enough to stop the unit from moving on the mount.
Step 4
Mark out and drill a 6mm/1/4’hole well above the waterline for the wire and feed wire
through. Cable tie wire where needed then apply sealant around hole and clean.
Step 5
Connect the wires to a joiner box if using more than one light then run a positive and
negative feed from a fused switch to the joiner box.
Short Trim Tab Light