☎
US (866)877-6637 |
☎
CAN (866)766-3426 |aquascapeinc.com
Instructions
STEP 1
• Thoroughly rinse the Aquatic Patio Pond
(Ex. 1).
STEP 2
• Place the patio pond in your desired
location (Ex. 2).
STEP 3
• Set the pump in the patio pond and feed
the electrical cord through the cord relief
in the corner (Ex. 3).
STEP 4
• Feed the fountain tubing through the
fountain hole in the corner and secure
the bamboo fountain in position (Ex. 4).
STEP 5
• Attach the hose to the outlet on the
water pump (Ex. 5).
STEP 6
• Fill the Aquatic Patio Pond with water
(Ex. 6).
TIP: If you are using a garden
hose to fill your Aquatic Patio
Pond, we recommend running the
hose for a few minutes to flush the
hose of any stagnant water.
STEP 7
• Plug the pump into a ground fault circuit
interrupter (GFCI) rated receptacle (Ex.
7).
STEP 8
• Use Pond Detoxifier (sold separately) or
allow the water to sit for 24 hours before
adding fish or plants (Ex. 8).
For more information about our company or products, please visit our website at aquascapeinc.com
or call us at US (866) 877-6637or CAN (866) 766-3426
©2018 Aquascape, Inc. • All Worldwide Rights Reserved
04/18
Ex. 1
Ex. 2
Ex. 3
Ex. 4
Ex. 5
Ex. 6
Ex. 7
Ex. 8
STEP 9
• Add plants to the pond (Ex. 9).
STEP 10
• If desired, a few small fish, such as
goldfish or Rosy Reds, can be added for
color and movement (Ex. 10).
General Maintenance
The Aquascape Aquatic Patio Pond is simple and easy
to maintain. We recommend performing a weekly water
change, using a bucket or small clean container to remove
approximately 15% of the water. Slowly add detoxified tap
water to replace the removed water. If using a garden hose,
run the hose for a few minutes to remove stagnant water.
Note: topping off evaporated water does not count as a
water change.
Winterization
In areas subject to freezing temperatures, the Patio Pond
should be stored indoors or in a frost-free location.
