Aquatec Beluga User manual

Assembly Instructions
Change of actuator Aquatec
®
Beluga
Status: 01.12.06 / Marketing Page 1 of 4 V/Allgemein/Montage/Montageanleitungen/Englisch
Beluga/Change actuator Beluga
1470111 Change actuator Beluga
Please read the assembly instructions carefully before you start to work!
A. REPAIR ELEMENTS
1. Actuator Aquatec
®
Beluga (order no. 15828) incl. pulley assembly
2. Motor bolt (order no. 14468)
3. Assembly instructions (4 pages)
B. TOOLS
1. Phillips screw driver size no. 1
2. Screw driver
3. Pliers
C. PREPARATION
Place the Aquatec
®
Beluga in a folded up position on a table.
D. DISMANTLING
1. Push the holder down, away from the motor until it loosens.

Assembly Instructions
Change of actuator Aquatec
®
Beluga
Status: 01.12.06 / Marketing Page 2 of 4 V/Allgemein/Montage/Montageanleitungen/Englisch
Beluga/Change actuator Beluga
1470111 Change actuator Beluga
2. Swing the actuator upwards. Attention: Take care of the cable, do not catch it!
3. Unscrew the lid of the electronic casing on the backrest. Loosen the Phillips screws
with screwdriver no. 1.
4. Remove the lid and the gasket carefully and unplug both motor cable plugs with the
pliers from the circuit board. Put the lid and the gasket aside!

Assembly Instructions
Change of actuator Aquatec
®
Beluga
Status: 01.12.06 / Marketing Page 3 of 4 V/Allgemein/Montage/Montageanleitungen/Englisch
Beluga/Change actuator Beluga
1470111 Change actuator Beluga
5. Remove the motor cable with gasket from the guiding.
6. Push the actuator down again.
7. Break the hooks of the motor bolt with the screw driver and remove the motor bolt.
8. Now the actuator can be removed.
E. ASSEMBLY
1. Take the motor out of the packing.
2. Replace the motor cable with gasket in the guiding.
3. Carefully replace the gasket of the lid.
4. Put the motor cable plugs on the connectors of the circuit board.
5. Close the electronic casing with the lid. Make sure that the gasket is in a correct
position.
6. Screw the lid on but please do not strip the screws!
7. Put the new actuator in its position on the backrest. Now put in the new motor bolt
until it is engaged.

Assembly Instructions
Change of actuator Aquatec
®
Beluga
Status: 01.12.06 / Marketing Page 4 of 4 V/Allgemein/Montage/Montageanleitungen/Englisch
Beluga/Change actuator Beluga
1470111 Change actuator Beluga
8. Push the actuator in the spindle catch. Make sure that the spring under the actuator
is in its correct position.
9. Hold the holder vertically to the actuator and press it carefully downwards until it is
engaged.