Arcade ARCE11 NKL User manual

Parts supplied:
Ø8.0mm
●Prior to installation check that all parts have been supplied.
●Assemble bath on a mat to protect against damage to bath surface.
●Bath diagram shown below is for reference only and bath legs fit to all baths.
●This product requires a two person lift - use proper lifting techniques.
●This installation guide does not include details of waste connection; final decision about installation of waste connection should
be taken by a suitably qualified person.
●Follow each step in turn.
4x 4x 4x 4x
4x 8x 4x 8x
4x
12
1x
M10 *50mm M5 *35mm 4mm
3 4
A
1 - 2
4x
Tools required:
Traditional Leg set
ARCE11 NKL
Extra washers have been provided
if adjustment for the mating of leg
to bath is required. Do not overtighten

B
Ø8.0mm
A
5
7
6
A
2 - 2
Once the bath is in the general
position ready to be plumbed in,
we suggest fitting the waste and
overflow to the bath.
Before you do this Burlington
insists you smear silicone
sealant around the inside of the
overflow and waste to ensure a
totally water tight seal. This is
shown in the diagram above.

B
Natural Stone Authentication
Congratulations on choosing a Natural Stone product.
Our products contain natural stone being a natural product there may be very slight variations
in the finish in certain light conditions. This adds to the uniqueness of our products with each
one having its own individual character a welcome rarity these days.
'The natural stone is porous like marble certain types of cleaners and bath oils may stain the
natural stone and therefore is a characteristic of the material. Should you decide to use such
products we strongly recommend the product is fully cleaned and rinsed after use as these
types of stains are not covered within the manufacturer’s warranty'.
For further information please visit the website for care maintenance of your special product.
www.arcadebathrooms.com
Care & Repair
Cosmetic repairs to your Natural Stone bath or basin
Should you be unfortunate enough to suffer cosmetic damage to your bath or basin during
installation oraccidentally at any time, these can usually be rectified quite easily by using a
fine grade abrasive waterproof paper. Lightly rub the affected area by keeping the area treated
to a minimum until the mark is removed, then use Scotch-Brite non-scratch scour pad with
warm soap water.
Please also use Scotch-Brite non-scratch scour pad with warm soap water for daily clean.
Warning
Never user cleaners / bleach products specifically manufactured for WC bowl cleaning as they
may damage your bath or basin. In addition to these we strongly recommend that applying
hair colouring is also not used over the bath as it may de-colour the natural stone.