Architectural Mailboxes 2572 User manual

Wall Mount Mailbox | Model 2572
MOUNTING INSTRUCTIONS
R
One Drill
x 4, screws
IMPORTANT! This
mailbox is intended to be
mounted under an eave or
another protected area.
Tools (not included)
Hardware (included)
x 4, plastic
anchors
1Using the guide on the back of these instructions,
mark the wall at the center of each crosshair. Use a
level to ensure a straight installation (optional).
2Drill into the wall at each marked location. Use a
1/4" drill bit for brick or other masonry wall. Use a
1/16" drill bit for wood wall.
One Drill Bit
1/4” masonry bit or 1/16”
wood bit
x4
1/4" masonry bit
- or -
1/16" wood bit
3Skip this step if installing into wood.
Insert the included plastic anchors into the drilled
holes. Gently tap them in if necessary.
4Insert the screws into the bottom two drilled holes
and secure with a screwdriver. Hang the mailbox
onto the secured screws using the bottom eyelet
holes on the back of the mailbox.
x4
One Phillips Screwdriver
5While the mailbox is hanging on the bottom screws,
insert the remaining two screws into the top holes
and secure with a screwdriver.
© 2020, Architectural Mailboxes, LLCRev. E
Questions, Comments, Concerns?
[email protected]
www.architecturalmailboxes.com
Find us on social media!
@archmailboxes
Need keys? Visit us at...
www.architecturalmailboxes.com/keys

© 2020, Architectural Mailboxes, LLCRev. E
INSTALLATION
TEMPLATE
Use this guide to mark the hole locations -
make sure the page is level before marking.