Argo POLIFEMO BILLY User manual

11
V 12/18
POLIFEMO BILLY
OPERATING INSTRUCTIONS
Read the instructions carefully before operating the appliance or carrying out maintenance operations.
Observe all the safety instructions; failure to observe the instructions may lead to accidents and/or damage.
Keep these instructions in a safe place for future reference.
EVAPORATIVE AIR COOLER
EN

12
V 12/18
GENERAL SAFETY INFORMATION
•Only use this appliance as described in this manual. Any other use
not recommended by the manufacturer may cause
•fire, electric shock or injury to people.
•Make sure that the type of mains power complies with the electrical
requirements of the appliance (220-240V~/50 Hz).
•This appliance can be used by children aged from 8 years and
above and people with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance in
a safe way and understand the hazards involved by a person
responsible for their safety.
•Children shall not play with the appliance.
•Children should be supervised to ensure that they do not play wit
the appliance.
•Cleaning and user maintenance shall not be made by children
without supervision.
•This product is not a toy. Children should be adequately
supervised to ensure that they do not play with the appliance.
•Switch OFF and unplug the unit when the appliance is not used or
for cleaning operations or for any maintenance.
•When not in use, disconnect the plug from the power outlet. Grasp
the plug not the main power chord, when disconnecting the plug.
•Drain water inside the tank when not in use for a long time.
•Do not use the product in environments with temperatures above
50°C or below 0°C.
•Do not expose to direct sunlight.
•Remove the plug and switch off the product before filling the tank
with demineralised water. Make sure the water is under the “MAX”
line of water level indication.
•To transfer the unit, move it backwards, because the front wheels
have a stop. Move slowly the unit to avoid any water splashing
from the tank.
•Do not use the humidify function for a long time in airtight place
(such as small closed room) to avoid too much humidity.
•Change the water frequently to keep It clean.
•This unit must be operated on stable and horizontal floor.
•This unit must not be exposed to dripping or spashing water.

13
V 12/18
•Do not install the unit in a confined space, such a bookcase or
built-in cabinet.
•Do not operate the unit near flammable liquids or exposive
atmospheres.
•Do not put heavy objects on the unit, It might cause damages or
malfunctions on the unit.
•WARNING: DO NOT DEPEND ON THE ON/OFF BUTTON
SWITCH AS THE SOLE MEANS OF
•DISCONNECTING POWER. WHEN SERVICING OR MOVING
THE FAN, ALWAYS UNPLUG THE POWER CORD.
In the event of any problems, switch off the appliance
immediately, do not attempt to repair it, and take it to
your local After-Sales Service Centre.
Do not remove or replace individual parts, as this
could affect product safety.
Do not touch the power cord with wet or damp
hands; risk of electric shock.
Do not insert objects into the appliance grilles.
This could cause leaks, short-circuits and damage to
the product.
Do not spray flammable substances or pesticides
near the product as they could damage it.
Do not use the appliance if the cord or plug is
damaged. Do not attempt to change the power cord
yourself. If the power cord is damaged, it must be
replaced by the manufacturer, dealer or a similarly
qualified person so as to avoid any safety risks.
Do not bend or stand heavy objects on the power
cord.
Do not disassemble the
appliance!
Warning!!! Do not touch
Risk of electric shock!
Warning!!! Do not touch
Risk of electric shock!
Prohibited!
Warning!!! Do not touch
Risk of electric shock!

14
V 12/18
Turn the switch off and unplug before carrying out
any maintenance work or moving the appliance.
Always unplug from the socket when the appliance is
not in use.
To disconnect the appliance, press the OFF button
and unplug from the socket. Only pull on the plug.
Do not pull the cord. Otherwise the cable may be
damaged or leaks, etc. may occur.
Do not pour water over the product: risk of short-
circuits and damage to the product.
Do not leave the airflow directed towards children
for long periods of time: it is not good for their
health.
DESCRIPTION OF PARTS
1. Top Panel
2. Control panel
3. Air outlet
4. Frontal panel
5. Water level display window
6. Air filter
7. evaporative panel
8. Power cord
9. Water tank lock
10. Casters

15
V 12/18
HOW TO USE THE APPLIANCE
The appliance does not need to be installed.
Position the unit on a flat, stable surface and connect the power cord to a suitable power socket (230 V~): the appliance
can be switched on using the ON/OFF button. The unit can be switched off using the OFF button and you will hear a
sound.
When you move it, use the handle on the back. Do not use this cooler in an area with high humidity, rich in dust or with a
temperature above 40 ° C.
This product can be used either as a fan, with 3 modes (Normal, NATURAL and Sleep) and 3 fan speed options (low,
medium and high), or as a cooler/humidifier: in this case the rear tank should be filled with demineralized water, up to but
not exceeding the maximum level as indicated.
As soon as the COOL function is activated, the fan speed drops to low, but 3 minutes after pressing the COOL key, the
speed returns to the speed selected before pressing the COOL key and all the LEDs, both the COOL function and any
LEDs NATURAL / SLEEP modes selection, horizontal and vertical flap swinging, as well as the display with the ambient
temperature turn off, to optimize consumption and prevent the lights from disturbing sleep during the night.
However, the unit continues to function properly in cooling mode.
If, in fact, after all the LEDs have gone out, one of the keys on the panel is pressed, the LED of the COOL function is
turned on again.
When the water in the tank falls below the minimum level, marked on the tank, the appliance emits a continuous sound for
a few seconds to signal a low water level, then cooling mode is stopped. The unit automatically shuts down when the tank
is removed.
The fan takes in air from the room and passes it through the dust filter and the evaporative panel, which is constantly
humidified thanks to a system which draws water from the tank and sprays it onto the panel. The incoming hot air makes
part of the water contained in the panel evaporate and is therefore cooler when released back into the room, which makes
it feel as though the temperature has dropped.
DISPLAY AND CONTROL PANEL
1. ON/OFF BUTTON
2. HORIZONTAL SWINGING
3. VERTICAL SWINGING
4. MODE BUTTON
5. COOL BUTTON
6. SPEED BUTTON
7. TIMER BUTTON
8. Display

16
V 12/18
REMOTE CONTROL
ON/OFF BUTTON
In power on state, press this button, the unit turns off and enters standby mode.
In power off state, press this button and it turns on.
SPEED BUTTON
In power state, press the SPEED button to switch among low, medium and high level.
COOL/HUMIDITY BUTTON
Press this button to turn on or turn off the "Cooler/Humidifier" mode: the LED lights up.
MODE BUTTON
In power on state, press this button to switch the working mode among Normal, Natural and Sleep.
- Normal mode: the unit runs at a constant speed setting;
- NATURAL mode: the unit runs at changing wind speed as set by the factory. In this mode the ventilation can be
changed and the correspondent Led will light on the display.
- Sleep mode:the unit runs at changing wind speed as set by the factory. In this mode the ventilation can be changed
and the correspondent Led will light on the display.
SWING BUTTON (OSC)
In power state, press this button to switch on/off the vertical and/or horizontal swinging of the flaps.
TIMER BUTTON
After turning on, the timer indicator is turned off by default and the digital tube displays ambient temperature; when the
button is first pressed, the timer sets to 1 hour; the time increases by 1 hour when the button is pressed every time, and
the timer can be set up to 8 hours; if the button is pressed again, the digital tube displays the room temperature, and the
timer turns off; press the button again to repeat the cycle;
HOW TO INSERT / REMOVE THE REMOTE CONTROL BATTERIES (refer to the diagram below)
Open the battery cover on the back of the remote control (press and pull the cover).
Place the battery inside the cover, making sure the polarity is correct.
Slot the cover back into position on the remote control.
Use Lithium/Manganese button cells, model no. CR2025 -3 V, compliant with Battery
Directive no. 2006/66/EC (supplied with the remote control).
INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EUROPEAN DIRECTIVE
2006/66/EC
Please replace the battery when its electrical charge has been exhausted: at the end of its useful life, it must not be disposed of
together with unsorted waste. It must be must be delivered to appropriate separated waste disposal plants or to dealers that
provide a similar service. Separate waste disposal of batteries prevents potential negative effects on the environment and human
health resulting from inadequate disposal, and also allows the materials from which it is made to be recovered and recycled in
order to achieve significant savings in terms of energy and resources. The separate disposal obligation is underlined by the
crossed-out dustbin symbol appearing on the battery. Illegal disposal of the product by the user shall result in the application of
administrative sanctions as defined by current regulations.

17
V 12/18
TANK MUST BE FILLED WITH DEMINERALIZED WATER FOR THE APPLIANCE TO OPERATE IN
COOLER/HUMIDIFIER MODE.
Opening Water tank
Fill water tank with demineralized
water
Do not exceed the maximum
limit indcated when filling the
tank
Place the synthetic ice pack in the tank
Close the water tank
Counter-rotate the tank knob by 90° and remove it from its slot; fill it with demineralized water, up to the maximum level mark.
Reposition the tank and turn the knob.
If you wish to keep the water in the tank below room temperature in order to maximize cooling in warmer months, leave one of
the two synthetic ice packs supplied in the freezer until solid, then add it to the water in the tank.
The ice will absorb heat from the water.
We recommend continuous use of the ice for optimal cooling capacity.
The first time it is used, you may detect a smell or the water may turn an unusual color: this does
not constitute a health risk.
FILLING THE WATER TANK

18
V 12/18
MAINTENANCE AND STORAGE
WARNING: ALWAYS UNPLUG THE APPLIANCE BEFORE CLEANING OR MAINTENANCE
PROCEDURES.
IMPORTANT: DO NOT SUBMERGE THE PRODUCT IN WATER
Cleaning the outside surface of the appliance
Use a soft cloth to remove any dust from the product.
If this is not enough, use a soft cloth dampened with water and a mild detergent at a temperature not exceeding 50°C. Let the
appliance dry completely before using it.
Do not use corrosive detergents or solvents such as petrol. Do not wash the appliance with water. Do not use oils, chemical
substances or other items that may damage the surface to clean it.
Use a vacuum cleaner to remove dust from the air inlet/outlet grilles.
Cleaning the dust filter, the cooling panel and the tank
Clean the dust filter frequently, at least once a month.
Remove the dust filter by pulling the knob on the cooling panel, as indicated in the diagram below.
STORAGE
If the appliance is not used for prolonged periods, disconnect the power cord and store the appliance with this manual in its
original packaging, in a cool and dry place.
Before packaging, the honeycomb filter and dust-proof filter should be dry, and there is no water in the tank.
INFORMATION FOR THE CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH
EUROPEAN DIRECTIVE 2012/19/EU
This appliance may not be scrapped with domestic waste at the end of its life cycle. We call your attention to the crucial role
played by the consumer in the re-use, recycling and other forms of recovery of such waste.
The appliance must be scrapped by a sorted waste disposal centre or by returning it to the retailer (no charge is levied for this
service), when you purchase a new equivalent appliance.
Sorted disposal of electric and electronic equipment prevents the negative effects on the environment and human health
resulting from improper scrapping, and also allows the materials from which it is made to be recovered and recycled, with
significant savings in terms of energy and resources. The sorted disposal requirement is indicated by the crossed waste bin
label affixed to the appliance.
Clean the dust filter using a soft brush or a vacuum cleaner, and
wash it in a solution of water and mild detergent.
Remove the cooling panel at the same time and soak it in a
solution of water and mild detergent.
Take out the tank and rinse it under running water, removing any
residue.
Let the filter, the panel and the tank dry completely after washing
them; then re-fit the components in the following order: water
tank, cooling panel and dust filter.
www.argoclima.com