Arlo VMC3030 User manual

1
Camera Quick Start Guide

2
Welcome
Thank you for choosing Arlo.
Getting started is easy.

3
What’s Included
Lithium 123 batteries
Mounting
screw
100% wireless
camera
Magnetic wall
mount
Available AFTER beta

4
Set Up and Sync Your Camera
Insert batteries
• Unlock the battery compartment by
sliding and holding the latch.
• Slide the battery door back and lift
it to open the compartment.
• Insert the batteries as shown and close
the battery door.

5

6
Sync your cameras with the base station
Bring the camera within one to three feet (30
to 100 centimeters) of the base station.
1’ - 3’
30 cm - 100 cm

7
Press the Sync button on the side of the
base station.
Wait for the sync status LED to
blink green.

8
Press the Sync button on top of
the camera.
Cameras must be synced one at a time.
Sync your cameras with the base station
(cont’d)

9
A blue LED on the camera blinks rapidly to
confirm sync.
The camera is ready for viewing.
Note: The LED blinks amber if the sync is not
successful. You must repeat the sync process.

10
You’re Done!
Congratulations! Your Arlo camera is set
up and ready to go.
To view useful tutorial videos, find
troubleshooting tips, or get support, visit
http://support.arlo.com.

11

12
©NETGEAR, Inc. NETGEAR, the NETGEAR Logo,
and Arlo are trademarks of NETGEAR, Inc.
Compliance
For regulatory compliance information, visit
http://www.netgear.com/about/regulatory/.
350 East Plumeria Drive
San Jose, CA 95134, USA
January 2015