ASONIC PRO 150MF User manual
ULTRASONIC CLEANING OF OBJECTS
is fast, ecient and eortless!
USER MANUAL
Thank you for purchasing ultrasonic cleaner. Please take the time to read these operating
instructions before use and retain them for future reference. Failure to follow these
instructions may lead to serious personal injury and damage to property.
Packing list:
One ultrasonic cleaning machine
One cleaning basket
One power cable
One user manual
Please verify your product pack for integrity against the aforesaid list. For any damage
to the packing or missing of any component, immediately contact your dealer.
ultrasonic cleaners
Model: PRO 150MF, PRO 300MF
www.asonic-ultrasoniccleaners.com
INSTALLATION AND PREAPARATION:
Carefully unpack the cleaner and remove all traces of packing materials from it. Visually inspect
the cleaner for any parts which may have become loose or damaged during transport. Place
the applience horizontally in a well-ventilated and dry location. Select appropriate detergent or
demineralized water based on properties of work piece to be cleaned.
OPERATION INSTRUCTIONS:
1. Pour the cleaning solution into the cleaning tank and place basket with items for cleaning into
tank. Firmly connect the power plug to appropriate grounded power socket (220V/50Hz) after
the tank is lled to ensure safety and turn on the red switch on the back of the unit. Ultrasonic
cleaner display will show time and temperature values used for previous cleaning process.
2. Use Heating/timer selector (SET) to choose between adjustment modes for temperature and
time. When you select desired parameter (temperature or time) use buttons UP (+) and DOWN
(-) to adjust values needed for your cleaning process. Single press of buttons (+) and (-) will
change values for 1 unit (1°C or 1 minute). If you press and hold buttons (+) or (-), values will
change rapidly by 10 units. Press set frequency (FR.) button to select optimal frequency (40 -
80 - 120 kHz.) for your cleaning process.
3. When all parameters are set, use Heating on/o button to turn the tank heater on. Heater will
turn o automatically when actual temperature reaches set temperature level, and will power
on again if actual temperature falls below set level.
4. Once temperature is achieved, activate ultrasonic operation by pressing On/O button.
Ultrasound will work until timer runs out or you can turn it o by pressing On/O button
again. Optionally you can activate ultrasonic operation by selecting Auto mode (AUTO) in which
ultrasonic cleaner will periodically cycle through preset frequencies. To deactivate Auto mode,
press the button again.
5. After cleaning turn o the red switch on the back of the unit and wait for liquid to cool down
before removing basket with items. Rinse items with clean water. Disconnect power cable and
discharge soiled liquid from the cleaner. Wipe the tank with dry soft cloth.
WARNING:
• The cleaner can work up to 240 minutes continuously, after that it has to rest for at least
30 minutes!
Heating indicator
Working indicator
Actual temperature
Set temperature
UP
DOWN
Heating on/o
Frequency indicator
Set time - minuets
Set time - seconds
Set frequency
Heating/timer selector
Auto mode
On/O
prodaja@avene.si
• Running the appliance without water will damage the cleaner.
• Do not throw objects into the tank or hit the appliance as it may cause damage.
SAFETY PERCAUTIONS:
This device is not intended to be used by individual with restricted physical, sensor or mental capacities
or those with lack of experience or knowledge, including children, unless they are supervised by an
individual who is responsible for their safety or have received proper training for operating the device.
Store the appliance and package material out of reach of children!
1. Always connect ultrasonic cleaner to AC220V/50Hz electricity outlet.
2. Warning: This product works at high voltage, do not use it in humid locations to avoid
electric shock.
3. Handle ultrasonic cleaner with care. Do not hit or throw the appliance to prevent damage
and impairment of performance and life span of it.
4. Perform cleaning of the appliance only after the power supply is disconnected.
5. Do not open the casing of the appliance to avoid any hazardous situations, as it works at
high voltage.
6. Do not use the ultrasonic cleaner if the power plug or power cord are damaged.
7. Remove the power plug from the socket before cleaning the applience or lling the liquid, if
the device is not going to be used for a long time or if a malfunction occurs.
8. Do not leave the applince plugged in electricity unattended.
9. Do not repair or make changes to the ultrasonic cleaner on your own. Always call authorized
service if there is a problem with the appliance.
10. During normal operation of ultrasonic generator, a consistent sound is resulted from the
harmonic oscillation of the tank body impacted by ultrasound waves. In case of discontinuous
oscillation, increase or reduce level of the cleaning uid by a small quantity to achieve
consistent sound, which will facilitate better cleaning of the item.
11. Long-term consecutive operation of ultrasonic cleaner may result in high temperature
inside the unit and accelerate aging of electronic components in it. Comply with time limit
recommendations.
12. Do not use inammable cleaning agents in the tank!
13. Do not operate ultrasonic cleaner without uid in the tank, as it may result in re.
14. Always ll at least 2/3 of the tank and maximum up to 2 cm below the upper edge of the tank.
15. Do not place the ultrasonic cleaner on a soft or other surface where ventilation will be
blocked.
16. Prevent splash of cleaning uid or water into the ultrasonic cleaner body, as it may cause
short circuiting, and thereby damage the appliance.
17. Any foreign matter falling into the tank should be taken out immediately.
18. Before changing or discharging the cleaning uid, make sure the uid is at normal
temperature and the ultrasonic wave generator is shut down and the power supply is
disconnected.
19. Clean the tank and casing of the ultrasonic cleaner with soft dry cloth after disconnecting
the power cable. Remove any dirt in the tank after each operation.
AVene d.o.o. | Tržaška cesta 134, Ljubljana | t: +386 41 566 618
www.asonic-ultrasoniccleaners.com | e: prodaja@avene.si
GUARANTEE CERTIFICATE
Thank You for purchasing this product, we hope you will be satised with it. If there is a need to repair the
product within the guarantee period, we advise you to contact your dealer rst. To avoid inconvenience,
before calling the service we advise you to re-read the instructions.
Guarantee period: 1 year / 12 months.
STATEMENT OF THE GUARANTOR:
• The product will have prescribed or declared characteristics during the guarantee period. The provider
of warranty within the warranty period, at its own expense provides service and removal of defects
arising from mismatches between actual and declared specications of the product. If provider of the
guarantee is unable to fulll this obligation, he will replace the product with a new one or with the model
of similar characteristics if the previous one in unavailable.
• Product will function correctly during the warranty period, if it is used in accordance with its intended
purpose and technical manual instructions. The provider of the guarantee commits to eliminate any
failures and shortcomings that prevent the product from working properly in the designated service
center.
• The owner of the device is obliged to make sure that guarantee is properly validated. If there is no
validation, guarantee is void.
• Service for these appliances will be available for 5 years after sale.
TERMS OF GUARANTEE:
Buyer can claim his rights by submitting original validated guarantee and original invoice with the date of
purchase. The warranty does not apply if altered, crossed out or damaged. Before operating the appliance
read the instruction that is supplied with each device.
1. The guarantee is considered valid when the defective device is delivered for service with the original
invoice and validated guarantee certicate.
2. Guarantee is void if:
• The appliance is used in a dierent manner and for longer periods than recommended in the instructions;
• Repairs are made (to the device) by unauthorized persons;
• There is installations of parts which are not original;
• The device was not properly handled;
• The product has suered an electric shock or lightning;
• The product was damaged during transport;
• The device was not properly installed;
• Damage was caused by mechanical hits to the device by the customer or third parties.
WHEN RECEIVING THE GOODS, BUYER MUST MAKE SURE THAT DEVICE IS COMPLETE WITH ALL PARTS AND
PHYSICALLY INTACT, LATER RECLAMATIONS ON AFOREMENTIONED ISSUES WILL NOT BE ACCEPTED.
For all repairs under the guarantee, please contact the importer and distributor for Europe:
AVene d.o.o., Tržaška cesta 134, 1000 Ljubljana, Slovenia, EU.
Disposal of Old Electrical & Electronic Equipment (Applicable in the European Union and other European countries with separate
collection systems) This symbol on the product or on its packaging indicates that this product shall not be treated as household
waste. Instead, it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment.
By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and
human health, which could otherwise be caused by inappropriate waste handling of this product. The recycling of materials will
help to conserve natural resources. For more detailed information about recycling of this product, please contact your local Civic
Oce, your household waste disposal service or the shop where you purchased the product.
MODEL: ASonic PRO 150MF, PRO 300MF
This manual suits for next models
1
Table of contents
Other ASONIC Ultrasonic Jewelry Cleaner manuals
