Astonica 50103302 User manual

IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
CONTACT OVERSTOCK.COM CUSTOMER SERVICE AT
1-800-843-2446
180106rev1
Read the instructions and precautions before use of this product
Please keep this instruction manual for future reference
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
CONTACT CONSUMER SUPPORT AT
1-800-843-2446
Warranty Information:
Products for Home Use
This item and or product is not covered under original manufacturer's warranty.
For warranty issues please contact the retailer directly at
1-800-843-2446
or
www.Overstock.com
Made in China
Distributed by:
Overstock.com
6350 South 3000 East
Salt Lake City, UT 84121
OV SKU No. 10085138-000-000
Model No. 50103302
Vista Armchair
Instruction Manual
Due to ongoing product development
the actual product or products may vary from
the illustrations or photos shown within this manual.
NOTE: This product is intended for residential, non-commercial use.

ASSEMBLY INSTRUCTIONS
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER. CONTACT CUSTOMER SERVICE AT
1-800-843-2446.
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
CAUTION: Do not over tighten screws, studs, and bolts. This may result in stripped threads.
1.(SEE FIGURE 1) Install threaded studs (E) into threaded holes of right arm/leg (C)
 and left arm/leg (D).
2.Place right arm/leg assembly (C) on one side with threaded studs upward.
3.Align threaded studs of arm/leg (C) with chair back (B) join arm/leg and chair back.
 Install mounting hardware, flat washer (F), spring washer (G) and nut (H), hand tighten only.
4.Align seat assembly (A) over threaded studs of right arm/leg assembly (C). Install mounting
 hardware flat washer (F), spring washer (G) and domed nuts (I), hand tighten only.
5.Align threaded studs of left arm/leg assembly (D) over seat and chair back. Install mounting
 hardware hand tighten only.
6.Stand chair upright and gradually tighten hardware in an "X" pattern.
7.Place chair assembly on one side and attach feet pad (J). Adjust feet pad until chair stands level.
8.Repeat steps 1 through 7 to assembly second chair.
A
B
C
D
Figure 1
PARTS & HARDWARE LIST
PART # DESCRIPTION QUANTITY
A 2
8
8
Seat
B 2Backrest
C 2Right Arm/Leg
D 2Left Arm/Leg
E 16Threaded Studs
F 16Flat Washers
Lock Washers
G 16
Hex Nuts
Acorn Nuts
Adjustable Feet Pad
H
I
J
8
E
F
H
I
J
G
B
A
D
E
C
F
G
I
F
G
H
NOTE: This product is intended for residential, non-commercial use.
12
Parts Detail