Astonica 50103056 User manual

OUTDOOR LIVING
ROUND PATIO TABLE
Instruction Manual
Read the instructions and precautions before use of this product
Please keep this instruction manual for future reference
MODEL NOS.: 50103056,50105032
Limited Warranty
World Factory, Inc.®Products for Home Use
World Factory, Inc.®(Seller) warrants to the original Buyer only, that each Astonica™ Product will be
free from defects in material and workmanship for a period of one (1) year from date of purchase.
SELLER’S SOLE OBLIGATION AND BUYER’S EXCLUSIVE REMEDY UNDER THIS LIMITED
WARRANTY SHALL BE THE REPAIR OR REPLACEMENT OF PARTS, WITHOUT CHARGE,
WHICH ARE DEFECTIVE IN MATERIAL OR WORKMANSHIP. ANY PA RTS AS DETERMINED BY
THE SELLER WHICH HAVE BEEN MISUSED; ABUSED OR DAMAGED EITHER DIRECTLY OR
INDIRECTLY FROM REPAIRS OR ALTERATIONS AT TEMPTED BY UNAUTHORIZED PERSONS;
IMPROPER MAINTENANCE, NEGLECT OR ACCIDENT ARE NOT COVERED BY THIS LIMITED
WARRANTY. This warranty does not apply to damage, heat-induced coloration changes, scratching or
alteration due to normal use or weathering. To make a claim under this Limited Warranty, you must
return the complete product, transportation prepaid, to any World Factory, Inc.®authorized service
center. Call 1-888-422-7800 for the location of the nearest authorized service center.
Additional Limitations
THIS LIMITED WARRANTY DOES NOT APPLY TO ACCESSORY OR CONSUMABLE ITEMS
RELAT ED TO THIS PRODUCT. ALL IMPLIED WARRANTIES SHALL BE LIMITED IN DURATION TO
ONE (1) YEAR FROM DATE OF PURCHASE. IN NO EVENT SHALL SELLER BE LIABLE FOR ANY
INCIDENTAL OR CONSEQUENTIAL DAMAGES, INCLUDING BUT NOT LIMITED TO LIABILITY
FOR LOSS OF PROFITS, ARISING FROM THE SALE OR USE OF THIS PRODUCT.
If any provision of this Limited Warranty is for any reason held to be invalid or unenforceable, such
provision shall not affect any other provision herein, this Limited Warranty shall be construed as if
such invalid and/or unenforceable provision had never been contained herein.
This Warranty contains the entire agreement between Seller and Buyer and supersedes any and all
prior agreements, arrangements, or understandings between the parties relating to product warranty.
Made in China
Distributed By:
World Factory, Inc. © 2001
280 Commerce St. • Southlake, TX 76092 USA
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER, CONTACT CUSTOMER SERVICE AT
1-888-422-7800.

23
TABLE ASSEMBLYPARTS LIST
1 Table Rim(A)
1 Tempered Glass To p(B)
4 Table Legs (C)
1 Leg Connector Ring (D)
12 Plastic Bolt Cap (E)
8 M6x28mm Bolts (F)
4 M6x15mm Bolts (G)
4 Flat Washers (H)
1 Angled Hex Driver (I)
1 Plastic Umbrella Hole Cap (J)
Carefully remove the contents from the package.
If any parts are missing do not attempt to use this product until they have been obtained and correctly installed.
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER, CONTACT CUSTOMER SERVICE AT
1-888-422-7800.
Assembly Instructions (Figure 2)
1. Unpack all parts and spread them out on a flat, non-scratching surface.
2. Turn Table Rim (A) upside down.
3. Insert the 4 Table Legs (C) into the slots in the edge of the Table Rim(A). Thread
an M6x15mm (G) Bolt and Flat Washer (H) into each Leg (C) to secure them in
place.
4. Attach each Leg (C) to the Leg Connector Ring (D) with the 8 M6x28mm
Bolts (F).
5. Turn the table frame assembly right side up onto its legs.
6. Tighten all bolts (F) and (G) securely with the Angled Hex Driver (I).
7. Place plastic bolt caps (E) over each of the bolts.
8. Carefully slide the Glass Top (B) into place. The smooth side should be facing
up. Insert the Plastic Umbrella Hole Cap (J) into the umbrella hole.
ASSEMBLY INSTRUCTIONS AND CONTENTS (Figure 2)
(A)
(B)
(C)
(D)
(E)
(F)
(G) (H)
(I)
(J)