Astonica 50100768 User manual

For warranty information, please refer to the back page of
this instruction manual.
270809rev1
Read the instructions and precautions before use of this product
Please keep this instruction manual for future reference
Limited Warranty
World Factory，Inc．Products for Home Use
World Factory, Inc. (Seller) warrants to the original Buyer only, that each Astonica Product will be free
from defects in material and workmanship for a period of one (1) year from date of purchase.
SELLER
WARRANTY SHALL BE THE REPAIR OR REPLACEMENT OF PARTS，WITHOUT CHARGE，WHICH
ARE DEFECTIVE IN MATERIAL OR WORKMANSHIP．ANY PARTS AS DETERMINED BY THE
SELLER WHICH HAVE BEEN MISUSED; ABUSED OR DAMAGED EITHER DIRECTLY OR INDIRECTLY
FROM REPAIRS OR ALTERATIONS ATTEMPTED BY UNAUTHORIZED PERSONS; IMPROPER
MAINTENANCE, NEGLECT OR ACCIDENT ARE NOT COVERED BY THIS LIMITED WARRANTY. This
warranty does not apply to damage, heat-induced coloration changes, scratching or alteration due to
normal use or weathering. To make a claim under this Limited Warranty, you must return the complete
product with proof of purchase, transportation prepaid, to any World Factory, Inc. authorized service
center. Call 1-888-424-3354 for the location of the nearest authorized service center.
Additional Limitations
THIS LIMITED WARRANTY DOES NOT APPLY TO ACCESSORY OR CONSUMABLE ITEMS RELATED
TO THIS PRODUCT. ALL IMPLIED WARRANTIES SHALL BE LIMITED IN DURATION TO ONE (1)
YEAR FROM DATE OF PURCHASE. IN NO EVENT SHALL SELLER BE LIABLE FOR ANY
INCIDENTAL OR CONSEQUENTIAL DAMAGES, INCLUDING BUT NOT LIMITED TO LIABILITY FOR
LOSS OF PROFITS, ARISING FROM THE SALE OR USE OF THIS PRODUCT.
If any provision of this Limited Warranty is for any reason held to be invalid or unenforceable, such
provision shall not affect any other provision herein, this Limited Warranty shall be construed as if
such invalid and/or unenforceable provision had never been contained herein.
This Warranty contains the entire agreement between Seller and Buyer and supersedes any and all
prior agreements, arrangements, or understandings between the parties relating to product warranty.
Made in China
Distributed by：
World Factory，Inc．
Irving，TX 75063
Model No：50100768
Stone Ridge 18" Square
Occasional Table
Instruction Manual
Due to ongoing product development
the actual product or products may vary from
the illustrations or photos shown within this manual.
NOTE: This product is intended for residential, non-commercial use.

TABLE RIM WITH GLASS 1
A
UPPER LEG 1
B
LOWER LEG 1
C
ST4*16 4
D
Figure 3
LEG RECEIVER
CAUTION：Do not over tighten
hardware and fasteners
Step 1:
With the help of another person,
place tabletop upside down on a
non-abrasive to avoid scratching
the top of the rim or glass. Identify
the upper leg and lower leg. Insert
the lower leg into upper leg.
Step 2:
Note the leg receivers in the table
rim. These leg receivers slide. If
necessary, adjust the leg receivers
into the proper position as shown
in drawing below. Also, if
applicable, position the flat plastic
supports so they are evenly spaced
within the table rim.
Step 3:
Insert the four legs into the leg
receivers bysnapping firmly into
place. Ensure all the legs
are secured in the leg receiver.
Then do the Fig.3. Use the ST4*16
to fix up the legs and leg receiver.
Turn the table in upright position.
The table is now ready for use.
NOTE：This product is intended for residential，non－commercial use．